1984 Ford Bronco pictures, photos, videos, and sounds

Randy Zrubek > 1984 Ford Bronco

1984 Ford Bronco

Owner:	Randy Zrubek
From:	Palacios, TX, U.S.A. (Other vehicles in TX)
Car & Truck:	1984 Ford Bronco (Other Ford Broncos in this club)
Clubs:	SuperFord.org (Other vehicles in this club) 2 Big Broncos Southern (Other vehicles in this club) FullSizeBronco.com (Other vehicles in this club)
Nickname:	Casual Mudder
Mileage:	205
Engine:	Custom "shaker" air intake assembly!!! 88 460 EFI, carb conv. w/ PME adapter, Holley 770cfm Truck Avenger, JEG's fuel system w/ 15 gal fuel cell, 140 gph electric pump, braided steel hoses & -AN fittings, HEI dizzy, Saginaw p/s pump conv.
Drivetrain:	C-6,NP208F manual t-case, 88F350 Dana60 &Sterling 10.25" SAS, custom front leafspring crossmember, re-centered H1 rims, 36x12.50R16.5 GYR RT-II tires
Notes:	Purchased vehicle from original owner in 8/01. New paint job 10/02 - PPG Ford medium blue metallic urethane and clear coat. S&W 10-pt roll cage kit, PRP Racing seats, RCI 5-pt harnesses, custom wiring harness, Tuffy console
Last Updated:	11/17/2008
Hits:	39380

Album

Folder		Hits	Created	Updated
whole view (0)	0	0	6/29/03	6/29/03
front view (10)	0	3,755	6/29/03	11/15/04
side view (21)	0	5,940	6/29/03	11/4/05
club stickers (2)	0	714	6/29/03	6/29/03
rear view (7)	0	1,436	6/29/03	11/15/04
Skyler softtop (10)	0	8,770	6/29/03	8/3/03
exhaust (2)	0	1,078	6/29/03	8/7/03
axle pics (14)	0	4,763	6/29/03	3/21/07
Interior pics (3)	1	920	3/7/05	3/7/05
SecretShakerProject (17)	0	9,666	6/29/03	4/18/06
S&W Racecars 10-pt cage kit (73)	0	36,095	3/1/05	9/11/06
PRP Racing seats (15)	0	3,875	3/7/05	9/11/06
Tuffy Security console (10)	0	5,718	3/7/05	5/4/05
2005 FSB RITS-HS,ARK (4)	0	706	8/1/05	8/1/05
pulling motor (15)	0	1,378	11/3/05	11/28/05
Skyjacker Class II 6" lift (16)	0	3,648	11/3/05	5/9/07
driveshafts rebuild (19)	0	2,296	11/30/05	11/17/08
Cleaning & Rustproofing Frame (21)	0	7,387	1/4/06	9/2/06
axle pivot bushing tool (8)	0	7,207	4/25/06	4/25/06
Herculiner (11)	0	1,413	5/9/06	8/29/06
Long's Ranch, TX 5/27/06 (35)	0	2,087	8/29/06	10/12/06
Commanchee Ridge (4)	0	463	9/11/06	10/12/06
Dana60 SAS (31)	0	10,987	9/11/06	5/11/08
460 Swap (24)	0	7,460	10/22/06	3/26/07
quick-connect door pins (6)	0	819	2/17/07	2/17/07
Hummer H1 rims (7)	0	1,346	5/8/07	5/8/07
Rear Shackle Flip (8)	0	2,858	6/11/07	6/11/07
Double-Flaring Brake Lines (11)	0	755	4/20/08	4/20/08
Dash panel (9)	0	523	4/20/08	10/6/08
FSB M&G 5-17-08 (3)	0	324	5/21/08	5/21/08
FSB M&G 11-15-08 (4)	0	41	11/17/08	11/17/08

Newest Media Files

Austin M&GDec08 009.jpg
9 hits | 72.39 KB | Posted: 11/17/08

Austin M&GDec08 008.jpg
10 hits | 60.29 KB | Posted: 11/17/08

Austin M&GDec08 007.jpg
13 hits | 90.16 KB | Posted: 11/17/08

Austin M&GDec08 006.jpg
9 hits | 77.94 KB | Posted: 11/17/08

sqds29.jpg
19 hits | 58.93 KB | Posted: 11/17/08
square driveshaft assembled, 28" long

sqds27.jpg
18 hits | 58.26 KB | Posted: 11/17/08
both pieces of driveshaft

sqds26.jpg
18 hits | 61.1 KB | Posted: 11/17/08
welded 1.5" tubing piece to end yoke

sqds25.jpg
20 hits | 77.31 KB | Posted: 11/17/08
old power saw works!

sqds22.jpg
16 hits | 68.29 KB | Posted: 11/17/08
cutting tubing on power saw

Most Viewed Files

digibronco12.jpg
1427 hits | 27.96 KB | Posted: 6/29/03
Skyler "fastback" softtop

digibronco14.jpg
1168 hits | 34.02 KB | Posted: 6/29/03

digibronco18.jpg
1111 hits | 28.16 KB | Posted: 6/29/03

thwbronco14.jpg
1045 hits | 31.72 KB | Posted: 7/22/03
hood closed, scoop installed. Project finished!

bronco-4-2006_021.jpg
1028 hits | 61.4 KB | Posted: 4/25/06
Insert all-thread into bushing, place socket on side of bushing without metal lip (shown reversed in pic)

cagekit12.jpg
996 hits | 40.03 KB | Posted: 3/9/05
12 pieces of the S&W 10-point cage kit. 1-5/8"x0.134" wall mild steel tubing, cost $220+shpg.

bronco-4-2006_032.jpg
979 hits | 68.54 KB | Posted: 4/25/06
reverse tool to install new bushing using washer under socket, hammer used only to keep bushing straight

bronco-4-2006_037.jpg
959 hits | 66.85 KB | Posted: 4/25/06
give a sharp blow with hammer, re-tighten nuts if needed

bronco-4-2006_033.jpg
950 hits | 64.73 KB | Posted: 4/25/06
place collar on other side, then plate and attach nuts&washers

Maintenance & Modification Logs

Hide log

Date	Type	Mileage	Title / Description	$ Amount
05/10/04	Modification	205000	S&W Race Cars cage kit Purchase of S&W Race Cars 10-point cage kit, part # 11-3560	339.66
06/05/02	Repair	180000	Driveshaft/battery cable B&B Muffler Shop replaced rear driveshaft u-joints and battery cables	339.19
01/17/02	Repair	173193	New exhaust system B&B Muffler Shop installed new cat and Flowmaster muffler w/ dual exits.	565.89
08/28/01	Repair	171446	Longblock kit install L&L Auto installed '85 NAPA 351W H.O. longblock kit. Part # unknown, as motor provided by previous owner with Bronco.	970.74
Total	2,215.48

Rearview Mirror

Featured Sites:

List your site here!
Click for details.