carpeted.jpg
916 hits | 45.52 KB | Posted: 8/20/04

I cut some 3/8 plywood to fit between the back of the front seats and little ledge in front of the b...
hinge.jpg
875 hits | 51.18 KB | Posted: 8/20/04

i learned the hard way that the hing needs to be right on the edge to allow the shelf to fold up. I...
carpeted2.jpg
854 hits | 66.16 KB | Posted: 8/20/04

top of the shelf carpeted. i had to clearance the shelf a little more on the drivers side.
shelfhingein.jpg
898 hits | 55.82 KB | Posted: 8/20/04

I took some time and made sure that the hinges, when mounted, would leave the shlef as level with th...
shelflevel.jpg
769 hits | 65.34 KB | Posted: 8/20/04

this is the amount of gap I required, and it could actually be made a little larger or the joint mov...
shelfsupports.jpg
851 hits | 61.49 KB | Posted: 8/20/04

I made a deck, that will hold both amps (when I am done) on one side, and secured the shelf supports...
screwscarpet.jpg
862 hits | 88.98 KB | Posted: 8/20/04

the screws holding the support are barely noticeable with the carpeting
shelfsupports2.jpg
863 hits | 57.99 KB | Posted: 8/20/04

should be enough clearance to keep the amps and inverter (once installed) cool.
completedfolded.jpg
791 hits | 59.59 KB | Posted: 8/20/04

The shelf in, with the rear carpeting on top of the seam, instead of down the ledge, and the carpete...
fullshelf.jpg
1107 hits | 53.81 KB | Posted: 8/20/04

Full shelf without the sub. Should fake out would be's
submockup.jpg
866 hits | 53.78 KB | Posted: 8/20/04

I was going to use this sub box, but its a little big, so i will have to find/make a smaller one.
ideashelf.jpg
967 hits | 55.14 KB | Posted: 8/20/04

I was also going to cut section from the tape towards the back, and then use carpeted wood in its pl...
angleiron.jpg
821 hits | 81.7 KB | Posted: 8/20/04

I welded some angle iron on to my swing away to mount some axleshafts etc.
mount.jpg
770 hits | 49.93 KB | Posted: 8/20/04

these are mounts I sourced through work. Lots of fire depts use these to mount assorted tools.
mounts.jpg
868 hits | 64.74 KB | Posted: 8/20/04

They can hold axle shafts, my 8 pound sledge, and hi lifts with ease. Im assured that sun and weat...
fullrack2.jpg
924 hits | 68.59 KB | Posted: 8/20/04

Here is how my tire carrier looks. the old 5 on 5.5 tire carrier has been changed to 8 on 6.5, and ...
boxin2.jpg
871 hits | 41.29 KB | Posted: 8/25/04

boxin1.jpg
830 hits | 53.03 KB | Posted: 8/25/04


About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog