|
|
Hits: 462
Size: 111.69 KB
Posted: 8/24/06
#6 was making a big 12psi, even on a wet compression test, so we put a Jasper long block in. At the... | 
Hits: 445
Size: 113.1 KB
Posted: 8/24/06
We didn't have time to clean & paint the intake manifold & accessory brackets, but maybe later... | 
Hits: 207
Size: 109.08 KB
Posted: 8/24/06
| 
Hits: 158
Size: 102.99 KB
Posted: 8/24/06
A direct-replacement radiator with the shroud dropped for the 3" body lift. | 
Hits: 349
Size: 88.29 KB
Posted: 8/24/06
|
Hits: 164
Size: 97.92 KB
Posted: 8/24/06
| 
Hits: 177
Size: 74.26 KB
Posted: 8/24/06
There was slight interference with the frame on this side, and the bolt holes on both sides did NOT ... | 
Hits: 171
Size: 92.68 KB
Posted: 8/24/06
This shows where the frame had to be cut to clear the header tube. The top bolt of the starter had ... | 
Hits: 365
Size: 97.79 KB
Posted: 8/24/06
| 
Hits: 158
Size: 57.25 KB
Posted: 8/24/06
|
Hits: 154
Size: 56.57 KB
Posted: 8/24/06
One of the previous exhaust shops cut that huge notch in the frame. | 
Hits: 137
Size: 89.36 KB
Posted: 8/24/06
| 
Hits: 152
Size: 83.08 KB
Posted: 8/24/06
Spraying CopperCoat on the gaskets made installing the headers MUCH easier. It was only used on the... | 
Hits: 1265
Size: 94.77 KB
Posted: 8/24/06
The large gold object is the oil pressure sender, which is installed in a 45-degree union on a 4" lo... | 
Hits: 151
Size: 85.05 KB
Posted: 8/24/06
The factory ex.man. bolts with studded heads don't fit with the header tubes, but one short bolt & n... |
Hits: 172
Size: 88.38 KB
Posted: 8/24/06
The secondary air pipes are in their correct position, & working, but the downtube to the cats was d... | 
Hits: 166
Size: 86.39 KB
Posted: 8/24/06
The instructions say to remove the starter, position the header, then install the starter, then bolt... | 
Hits: 227
Size: 67.76 KB
Posted: 8/24/06
Because of the body lift, the block at the L end of the crossover tube on the back of the heads come... | 
Hits: 150
Size: 78.7 KB
Posted: 8/24/06
Because of the body lift, the block at the L end of the crossover tube on the back of the heads come... | 
Hits: 218
Size: 88.92 KB
Posted: 8/24/06
The coil support brace couldn't be reinstalled, but since the dipstick was also loose, its brace was... |
Hits: 293
Size: 107.04 KB
Posted: 8/24/06
The coil support brace couldn't be reinstalled, but since the dipstick was also loose, its brace was... | 
Hits: 270
Size: 100.65 KB
Posted: 8/24/06
The coil support brace couldn't be reinstalled, but since the dipstick was also loose, its brace was... | | | |
Engine Replacement