sas1.JPG
1031 hits | 53.18 KB | Posted: 4/12/04
Used 4"x8"x1/4" steel and cut them at about 15 degrees to relieve the stress on the bushing at ride ...

sas2.JPG
780 hits | 48.4 KB | Posted: 4/12/04
Shows the angle.

sas3.JPG
797 hits | 61.23 KB | Posted: 4/12/04
Welded a 3/16" thick plate to the top. It is then bolted and welded to the frame.

sas4.JPG
730 hits | 61.46 KB | Posted: 4/12/04
For the trac bar mount i used 2.5"x2.5"x1/4" steel

sas5.JPG
708 hits | 63.37 KB | Posted: 4/12/04
Chopped it up and welded it together.

sas6.JPG
813 hits | 61.71 KB | Posted: 4/12/04
This just shows the piece that will be welded to the mount and connect to the crossmember under the ...

sas8.JPG
765 hits | 56.23 KB | Posted: 4/12/04
I cut the opening for the bushing and marked the hole for the bolt. Also welded a piece of 1/4" thic...

sas9.JPG
846 hits | 67.5 KB | Posted: 4/12/04
Welded it to the frame and then welded the brace on (not visible)

04190401.JPG
1027 hits | 52.83 KB | Posted: 4/20/04

04190405.JPG
1063 hits | 66.37 KB | Posted: 4/20/04

04190406.JPG
1333 hits | 68.21 KB | Posted: 4/20/04

04190407.JPG
1418 hits | 72.75 KB | Posted: 4/20/04

04190408.JPG
1373 hits | 67.05 KB | Posted: 4/20/04

04190410.JPG
1301 hits | 64.83 KB | Posted: 4/20/04

04190412.JPG
1350 hits | 67.41 KB | Posted: 4/20/04