Sirius18.jpg 461 hits | 36.81 KB | Posted: 8/27/06 Attached the Sirius antenna magnet to the middle of the dash. This will be my first testing area. If there
are no dropouts, it'll stay, otherwise, I may have to go outside the car with it.
Sirius17.jpg 372 hits | 23.78 KB | Posted: 8/27/06 Pop up the upper dash to run the cable under.
Sirius16.jpg 395 hits | 21.74 KB | Posted: 8/27/06 Sirius Antenna cable runs up along side the dash to the top of the dash.
Sirius15.jpg 371 hits | 34.54 KB | Posted: 8/27/06 Splice/sodder the Sirius tuner's power harness in with the Auxillary 12V plug. Wrapped it up in some electrical tape afterward.
Sirius14.jpg 356 hits | 22.21 KB | Posted: 8/27/06 Tuner in the glovebox with the Goose's Owner's Manual.
Sirius13.jpg 372 hits | 20.86 KB | Posted: 8/27/06 Tuner sitting nicely in the back of the glovebox.
Antenna runs out the right side.
Sirius12.jpg 335 hits | 25.83 KB | Posted: 8/27/06 Drilled a hole in the back for the IP-bus connector to the radio and the power harness for the tuner. Applied some peel n seal to act as a deadener in there with the flimsy plastic of the glovebox. Also , I was only able to secure one side of the t...
Sirius18.jpg 461 hits | 36.81 KB | Posted: 8/27/06 Attached the Sirius antenna magnet to the middle of the dash. This will be my first testing area. If there
are no dropouts, it'll stay, otherwise, I may have to go outside the car with it.
Sirius16.jpg 395 hits | 21.74 KB | Posted: 8/27/06 Sirius Antenna cable runs up along side the dash to the top of the dash.
Sirius7.jpg 374 hits | 22.75 KB | Posted: 8/27/06 Here's the panel dropped with just the connector to the auxillary 12v plug still attached.
Sirius13.jpg 372 hits | 20.86 KB | Posted: 8/27/06 Tuner sitting nicely in the back of the glovebox.
Antenna runs out the right side.
Sirius17.jpg 372 hits | 23.78 KB | Posted: 8/27/06 Pop up the upper dash to run the cable under.
Sirius15.jpg 371 hits | 34.54 KB | Posted: 8/27/06 Splice/sodder the Sirius tuner's power harness in with the Auxillary 12V plug. Wrapped it up in some electrical tape afterward.
Pioneer1.jpg 362 hits | 49.5 KB | Posted: 8/27/06 Face removed from stock radio, dremeled out and
some face buttons glued back on. The eject button fell off temporarily.
