FSA94S91E-BrakeWedge1.jpg
5100 hits | 45.36 KB | Posted: 1/2/07
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Veh...

FSA94S91E-BrakeWedge2.jpg
3126 hits | 60.3 KB | Posted: 1/2/07
3. NOTE: This step is not necessary for Explorer/Ranger vehicles. Check the release rod and spring ...

FSA94S91E-BrakeWedge3.jpg
3351 hits | 55.4 KB | Posted: 1/2/07
1. Without moving the parking brake pedal, inspect the parking brake control assembly to determine i...

FSA94S91E-BrakeWedge4.jpg
3709 hits | 50.28 KB | Posted: 1/2/07
LOCK-IN WEDGE SERVICE PROCEDURE

NOTE: This procedure should only be performed if the lock-in wedg...

FSA94S91E-BrakeWedge5.jpg
3004 hits | 56.07 KB | Posted: 1/2/07
2. Visually inspect to make sure that the pawl is fully seated in the bottom of a sector gear tooth....

FSA94S91E-BrakeWedge6.jpg
2610 hits | 43.54 KB | Posted: 1/2/07
3. When the pawl and sector gear are fully engaged, depress the parking brake pedal until a full tra...

FSA94S91E-BrakeWedge7.jpg
2820 hits | 33.94 KB | Posted: 1/2/07
6. Using the needle nose pliers, insert the lock-in wedge between the pawl and the sector gear with ...

FSA94S91E-BrakeWedge8.jpg
2646 hits | 46.27 KB | Posted: 1/2/07
7. Position a punch on the drive area of the lock-in wedge.

FSA94S91E-BrakeWedge9.jpg
2902 hits | 67 KB | Posted: 1/2/07
7. (continued) Using a hammer, drive the lock-in wedge between the pawl and the sector gear, until t...

FSA94S91E-BrakeWedge10.jpg
5684 hits | 40.57 KB | Posted: 1/2/07
9. Apply and release the parking brake at least two times, allowing the pedal to return each time wi...