SpkPlug01.JPG
290 hits | 47.66 KB | Posted: 10/27/07
Carefully remove the separated terminal from the spark plug and clean out any remaining wire fragmen...

SpkPlug02.JPG
297 hits | 42.43 KB | Posted: 10/27/07
Forcefully push the wire further into the boot. It may be necessary to pull it first if the boot is...

SpkPlug03.JPG
260 hits | 39.82 KB | Posted: 10/27/07
Once the wire extends from the plug end of the boot a few inches, open the clamp section of the term...

SpkPlug04.JPG
235 hits | 39.6 KB | Posted: 10/27/07
Carefully remove the outer insulation from the end of the plug wire. Don't cut any more than necess...

SpkPlug05.JPG
236 hits | 34.01 KB | Posted: 10/27/07
Fold the conductor over the end of the insulation and insert it into the clamp end of the terminal s...

SpkPlug06.JPG
230 hits | 33.68 KB | Posted: 10/27/07
Fold the conductor over the end of the insulation and insert it into the clamp end of the terminal s...

SpkPlug07.JPG
247 hits | 33.52 KB | Posted: 10/27/07
Bending each side a little at a time, close the clamp ends into the wire insulation as tightly as po...

SpkPlug08.JPG
236 hits | 49 KB | Posted: 10/27/07
VERY slowly, pull the boot back down the wire toward the terminal.

SpkPlug09.JPG
233 hits | 48.96 KB | Posted: 10/27/07
The wire will move more easily when the terminal goes through the bend (where it should stop), so wo...

SpkPlug10.JPG
223 hits | 48.37 KB | Posted: 10/27/07
The terminal will lie flat inside the boot when it reaches the proper position.