File 20 of 136
Prev | Next

Share This
Url
Tag
Img
Thumb


startersolswap.jpg | Hits: 10825 | Posted on: 5/25/11 | View Low-Res

Starter Wiring for original (swinging pole shoe) or PMGR (solenoid-type)
IF THE IMAGE IS TOO SMALL, click it.

To swap from old to new: the original (~4ga) cable is moved to the battery side (M1) of the starter relay (E9TZ-11450-B), and a new smaller wire (~14-8ga) is run from the relay output (M2) to the new starter S terminal. No other terminals on the starter relay should be moved, but the starter cable should be adjacent to the battery cable. Clean all the ring terminals and posts with a wire brush so they make good contact to each other.



If the PMGR starter was shipped with a jumper from the large upper terminal to the small terminal, REMOVE & DISCARD it.

Don't overlook the battery terminals. Not only will bad ones prevent a high-torque starter from putting out its max torque; they can cause a WIDE variety of other symptoms & problems.



See also:
. . . . . .
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog