DSC_0618.JPG 378 hits | 100.7 KB | Posted: 7/28/10 should've checked for clearance first. The hood hinge hit the fuse holder when the hood was closed, ...
DSC_0620.JPG 397 hits | 137.69 KB | Posted: 7/29/10 Stock 95 amp 3G on the right. 130 amp 3G on the left. came from a cash for clunkers explorer. I save...
DSC_0622.JPG 397 hits | 121.33 KB | Posted: 7/29/10 Test run with the alt bolted up.
DSC_0628.JPG 390 hits | 95.91 KB | Posted: 8/3/10 4 gauge Welding cable. A damp cloth is wrapped around the insulation while tinning and soldering to ...
DSC_0629.JPG 378 hits | 95.25 KB | Posted: 8/3/10 Cable end tinned with flux core solder.
DSC_0630.JPG 397 hits | 114.83 KB | Posted: 8/3/10 Filling the copper lug with flux core solder.
DSC_0633.JPG 651 hits | 91.97 KB | Posted: 8/3/10 Flux gathered on top of the solder.
DSC_0634.JPG 527 hits | 100.02 KB | Posted: 8/3/10 Dabbing the excess flux out with a drill bit wrapped in a rag.
DSC_0632.JPG 508 hits | 96.5 KB | Posted: 8/3/10 Inserting the cable into the lug. this is done while heating the lug.
DSC_0640.JPG 383 hits | 119.4 KB | Posted: 8/3/10 Completed charge cable. dielectric grease and 2 layers of heat shrink on both ends. cable wrapped in...
DSC_0689.JPG 398 hits | 119.9 KB | Posted: 8/10/10 Charge cable installed. The stock exciter wire runs in the small wire loom taped to the charge cable...
DSC_0691.JPG 508 hits | 112.52 KB | Posted: 8/10/10 Balkamp Mega fuse holder installed with 175 amp mega fuse.
3g alternator
