000_0032.JPG
1374 hits | 53.66 KB | Posted: 1/3/06
STEP 1:sand with dremel this area to reveal the power bar.

000_0035.JPG
1270 hits | 53.88 KB | Posted: 1/3/06
STEP 2: use cutting wheel to remove the power bar cut a square out.

000_0040.JPG
1188 hits | 43.69 KB | Posted: 1/3/06
STEP 3: remove cut section. usually fall out with a touch!

000_0041.JPG
1275 hits | 61.8 KB | Posted: 1/3/06
STEP 4: You need a post! what a cheap way an old spark plug use hammer to break ceramic. cut a piece...

000_0042.JPG
1297 hits | 55.98 KB | Posted: 1/3/06
STEP 5: Drill a hole in the center for the post
use a size smaller than diameter of post. youll nee...

000_0044.JPG
1309 hits | 51.32 KB | Posted: 1/3/06
Use a plastic bond. (2 part mix) and fill the hole(this is needed to protect metal from grounding) t...