SuperMotors.net Forums

Forums > Car and Truck Make and Model Specific > Crown Victoria, Marauder, Marquis

2001 crown vic parking break

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 638

You must be logged in to post in or subscribe to this thread. Pages: 1

2001crownvic • FRAMINGHAM, MA, USA • Registered on 6/26/2017 • 1 post • 1 Vehicle

Posted:6/26/2017 10:46 I was replacing my brakes (calipers rotors and pads) in the rear of my crown vic i was not able to pull off the rotor at first i assumed that was because of rust but after hitting it 100\\'s of times with a hammer i realized the parking brake was stopping it from pulling off so i used a puller and now the break sheild is split will this effect replacing the brake shoes? and is there something i can do so that i dont have to replace the brake sheid because that means removing the axle?

hondaclf • Baldwin, NY, USA • Registered on 2/25/2009 • 244 posts • 4 Vehicles

Posted:6/26/2017 12:34 Are you replacing the e-brake parts too? You may be able to smack it back relatively flat to keep it out of the way and not be a problem.

Forums > Car and Truck Make and Model Specific > Crown Victoria, Marauder, Marquis

2001 crown vic parking break

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 638

You must be logged in to post in or subscribe to this thread. Pages: 1