mud 1.jpg
673 hits | 92.69 KB | Posted: 5/18/05
I however took a line a little too far to the left, see where my diff impression is? Got a little stuck and had to be strapped out by Rob.
(Posted in: Slaughterhouse Gulch, May 05)

mud2.jpg
665 hits | 103.17 KB | Posted: 5/18/05
After just being strapped out the mud flowed back into the ruts.
(Posted in: Slaughterhouse Gulch, May 05)

mud 7.jpg
564 hits | 113.16 KB | Posted: 5/18/05
This hole ate my 37" rubber.
(Posted in: Slaughterhouse Gulch, May 05)

mud 9.jpg
624 hits | 111.02 KB | Posted: 5/18/05
Another view of hole.
(Posted in: Slaughterhouse Gulch, May 05)

A rock that would be trouble.jpg
526 hits | 80.9 KB | Posted: 5/18/05
The funny looking rock in the middle does not look that big but compare it later on. It was right in the middle of the trail.
(Posted in: China Wall, May 05)

Starting up hill looking for the line.jpg
561 hits | 87.96 KB | Posted: 5/18/05
Starting up the hill and looking for a decent line.
(Posted in: China Wall, May 05)

Notice rock next to pas. front tire.jpg
525 hits | 88.5 KB | Posted: 5/18/05
Notice the rock next to the passenger side front tire. My friend from picture #1.
(Posted in: China Wall, May 05)

Kept sliding off drv side rock.jpg
587 hits | 85.93 KB | Posted: 5/18/05
Kept climbing up rock on Drivers side and sliding off...
(Posted in: China Wall, May 05)

Working my way around it.jpg
489 hits | 94.22 KB | Posted: 5/18/05
Trying to work my way between both rocks. Ended up catching my passenger side rocker panel pretty good.
(Posted in: China Wall, May 05)

Kept climbing up and sliding off.jpg
510 hits | 86.73 KB | Posted: 5/18/05
More climbing and sliding. Guy in Suspenders is on Colorado4x4 and was giving me a spot.
(Posted in: China Wall, May 05)

And again up.jpg
527 hits | 82.48 KB | Posted: 5/18/05
Another try.
(Posted in: China Wall, May 05)

And again off note rubber on top of rock.jpg
566 hits | 79.58 KB | Posted: 5/18/05
And slid right off again, notice the rubber building up on top of the drivers side rock. Stupid SSR's...
(Posted in: China Wall, May 05)

Try different angle.jpg
532 hits | 75.38 KB | Posted: 5/18/05
Tried a slightly different angle to work my way between the rocks.
(Posted in: China Wall, May 05)

Finally got around.jpg
483 hits | 75.59 KB | Posted: 5/18/05
Finally worked my way around.
(Posted in: China Wall, May 05)

Going up.jpg
542 hits | 67.29 KB | Posted: 5/18/05
Going up!
(Posted in: China Wall, May 05)

Almost.jpg
579 hits | 72.46 KB | Posted: 5/18/05
Almost over the hill!
(Posted in: China Wall, May 05)

And over.jpg
624 hits | 65.93 KB | Posted: 5/18/05
And over the hill obsticle.
(Posted in: China Wall, May 05)

DSCN1818.jpg
1879 hits | 56.31 KB | Posted: 4/15/05
Flatbed F250 came in handy
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2045.JPG
1371 hits | 59.21 KB | Posted: 5/8/05
Axle perch cutting to move leaf spring spacing from 32"-36"
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2046.JPG
1348 hits | 87.79 KB | Posted: 5/8/05
How much i cut off, I used a chopsaw and cut it by hand, with great care and welding gloves on, and using a pair of locking pliers.
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2151.jpg
1178 hits | 39.54 KB | Posted: 5/18/05
will drill the rest of the holes for this bracket once i check to make sure shackle angle is decent.
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2155.jpg
1087 hits | 33.76 KB | Posted: 5/18/05
the brakelines that were on the built D60 when i got it, seem to hookup to the TTB hardlines just fine luckily
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2156.jpg
1107 hits | 23.14 KB | Posted: 5/18/05
no leaky leaky
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2157.jpg
1155 hits | 48.69 KB | Posted: 5/18/05
Hooked up to the TTB hardline, great luck on my part.
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2158.jpg
1132 hits | 37.67 KB | Posted: 5/18/05
line measurement..
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2159.jpg
1055 hits | 21.63 KB | Posted: 5/18/05
29"! I DOUBT these lines will be being stretched by any means
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2160.jpg
1345 hits | 35.87 KB | Posted: 5/18/05
6" extended TTB line compared to the line on the 60..bit of difference
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2152.jpg
774 hits | 55.03 KB | Posted: 5/18/05
97 10.25 Sterling rear axle, out of an f350. Has since been rebuilt with Yukon 4.88 gears (long pinion/late model), Detroit full locker, and a yukon master install kit. Got drums turned, new cylinders, brake shoes, seals, and synthetic fluid, all to...
(Posted in: 97 10.25 Sterling Swap)

IMG_2708dfdsaf.JPG
2142 hits | 83.72 KB | Posted: 5/19/05
(Posted in: Roll Cage)

DSCN2031.jpg
1192 hits | 42.49 KB | Posted: 5/5/05
beginning of front hangers
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2041.JPG
2174 hits | 88.53 KB | Posted: 5/8/05
Front axle hanger tacked into place until final fitting and measurements
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2047.JPG
1215 hits | 69.56 KB | Posted: 5/8/05
mocked up
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2048.JPG
1198 hits | 52.96 KB | Posted: 5/8/05
Tacked in place until final fitting
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2178.jpg
1176 hits | 43.43 KB | Posted: 5/19/05
Cage Offroad Nitrogen Shocks, 14" travel.
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2179.jpg
1177 hits | 43.05 KB | Posted: 5/19/05
Monroe Steering Stabalizer
(Posted in: 78 Dana 60 Leaf SAS)

DSCN2181.jpg
1056 hits | 24.27 KB | Posted: 5/19/05
Part #
(Posted in: 78 Dana 60 Leaf SAS)

tombstone.jpg
433 hits | 31.77 KB | Posted: 5/19/05
(Posted in: my pictures)

Posing while going down.JPG
505 hits | 106.43 KB | Posted: 5/20/05
Cool picture while going down steep part.
(Posted in: China Wall, May 05)

more posing.JPG
596 hits | 121.19 KB | Posted: 5/20/05
Another one while going down.
(Posted in: China Wall, May 05)

Cool side view.JPG
562 hits | 125.13 KB | Posted: 5/20/05
Side view going down hill.
(Posted in: China Wall, May 05)

back view of going down.JPG
493 hits | 125.08 KB | Posted: 5/20/05
View from the back going down hill.
(Posted in: China Wall, May 05)

Does not look that steep.JPG
521 hits | 111.51 KB | Posted: 5/20/05
Looks like a driveway eh?
(Posted in: China Wall, May 05)

working my way aroung that big rock.JPG
512 hits | 106.75 KB | Posted: 5/20/05
Working my way around that big rock in the middle that gave me so much trouble going up.
(Posted in: China Wall, May 05)

Did not even touch it going down.JPG
524 hits | 82.96 KB | Posted: 5/20/05
Look at that, did not even touch it while going down.
(Posted in: China Wall, May 05)

And down.JPG
535 hits | 85.28 KB | Posted: 5/20/05
Down and out of this hill.
(Posted in: China Wall, May 05)