saginaw_hose_4.jpg
1452 hits | 70.61 KB | Posted: 6/29/03
Another mount on a 1982 4.9L Bronco. This one has the HD case, notice how the high presure outlet was rotated and using the stock hose. Stock V pully.
(Posted in: Saginaw swap)

saginaw_bracket_2.jpg
1391 hits | 53.84 KB | Posted: 6/29/03
Another mount on a 5.8L Bronco, with stock pully and canister
(Posted in: Saginaw swap)

bummper_rjm_1.jpg
1312 hits | 36.56 KB | Posted: 6/29/03
This is what i have drawn up for my rear bumper. Not sure on measurements yet. i will be using a mix of 1/8" and 1/4" steels.
(Posted in: Protection)

tire_carrier_rjm_1.jpg
930 hits | 9.29 KB | Posted: 6/29/03
(Posted in: Protection)

FRPP_syp_01.JPG
994 hits | 60.23 KB | Posted: 6/29/03
This is a Spy photo I took of a NEW Ford EFI harness. These 4 wires were cutoff and taped over inside. Proof that this harness is not designed for EFI swaps, simply a left-overs re-sold to the public.
(Posted in: Brian Wickert Harness)

FRPP_syp_02.jpg
922 hits | 17.04 KB | Posted: 6/29/03
This is the un-used "low Oil level" light that is inside the Ford EFI harness. This wire is in the O2 harness and continues all the way to the green connector by the EEC plug.
(Posted in: Brian Wickert Harness)

FRPP_syp_03.jpg
974 hits | 13.28 KB | Posted: 6/29/03
It seems that Ford used jumper wires inside different harnesses to conect ciruits in other harnesses. This is confusing at best. I have found 3 different jumper configurations in the O2 harness so far.
(Posted in: Brian Wickert Harness)

bw_harness_05.JPG
1024 hits | 39.24 KB | Posted: 6/29/03
(top row from left) EFI fuse block, EFI relay pack, Baro sensor, Self-test plugs, Computer
(bottom row from left) Main vehicle fuse block, Main battery possitive terminal, Starter seloniod, Check engine light
(Posted in: Brian Wickert Harness)

bw_harness_12.JPG
911 hits | 56.18 KB | Posted: 6/29/03
Dash connections, Oil PSI, Temp, Tach. Ignition switch connections Run & start.
Fuel pump connection
(Posted in: Brian Wickert Harness)

EB_EEC_hole_01.jpg
1037 hits | 39.69 KB | Posted: 6/29/03
(Posted in: EB EFI harness)

EB_EEC_hole_02.jpg
1047 hits | 44.3 KB | Posted: 6/29/03
(Posted in: EB EFI harness)

EB_EEC_hole_03.jpg
1028 hits | 38.83 KB | Posted: 6/29/03
(Posted in: EB EFI harness)

EB_EEC_hole_04.jpg
982 hits | 42.2 KB | Posted: 6/29/03
(Posted in: EB EFI harness)

EB_EEC_hole_05.jpg
944 hits | 42.36 KB | Posted: 6/29/03
(Posted in: EB EFI harness)

EB EFI.jpg
1066 hits | 78.7 KB | Posted: 7/10/03
(Posted in: EB EFI harness)

vacuum lines 1.jpg
1083 hits | 83.19 KB | Posted: 7/24/03
(Posted in: vacuum lines)

vacuum lines 2.jpg
905 hits | 72 KB | Posted: 7/24/03
(Posted in: vacuum lines)

TG Harness 12.JPG
936 hits | 58.72 KB | Posted: 7/31/03
Relay and Fuse Blocks. 2 wires to hook up: YELLOW = Starter Relay "Batt" RED = Starter Relay "S"
(Posted in: Terry Gorsuch Harness)

TG Harness 13.JPG
1064 hits | 77.59 KB | Posted: 7/31/03
6 Wires to hook up: ORANGE = Ingition Switch Run WHITE = Oil PSI Gauge RED = Temp Gause GREEN = Tach RED&BLK = Check Engine Light
(Posted in: Terry Gorsuch Harness)

Rick Shirk Harness 03.JPG
909 hits | 55.73 KB | Posted: 8/3/03
Relay and Fuse Blocks. MAF plug & EGR seloniod plug. YELLOW = starter seloniod "batt" RED = starter seloniod "S"
(Posted in: Rick Shirk Harness)

Rick Shirk Harness 04.JPG
955 hits | 47.81 KB | Posted: 8/3/03
Computer 60-pin plug RED = temp gauge WHITE = oil psi gauge GREEN = tach ORANGE = igintion switch "run" YELLOW/BLACK (paired wires) = check engine light
(Posted in: Rick Shirk Harness)

TailGate1.jpg
803 hits | 79.37 KB | Posted: 10/27/03
(Posted in: TG Swap)

TailGate2.jpg
793 hits | 76.39 KB | Posted: 10/27/03
(Posted in: TG Swap)

TailGate3.jpg
926 hits | 61.76 KB | Posted: 10/27/03
(Posted in: TG Swap)

TailGate4.jpg
738 hits | 81.94 KB | Posted: 10/27/03
(Posted in: TG Swap)

TailGate5.jpg
791 hits | 88.99 KB | Posted: 10/27/03
(Posted in: TG Swap)

TailGate6.jpg
793 hits | 75.34 KB | Posted: 10/27/03
(Posted in: TG Swap)

Bronco Rust 3.jpg
810 hits | 62.59 KB | Posted: 10/28/03
(Posted in: TG Swap)

TailGate7.jpg
801 hits | 39.62 KB | Posted: 11/15/03
(Posted in: TG Swap)

TailGate8.jpg
784 hits | 44.58 KB | Posted: 11/15/03
(Posted in: TG Swap)

TailGate9.jpg
768 hits | 41.52 KB | Posted: 11/15/03
(Posted in: TG Swap)

TailGate10.jpg
776 hits | 42.18 KB | Posted: 11/15/03
(Posted in: TG Swap)

TailGate11.jpg
806 hits | 64.05 KB | Posted: 11/15/03
(Posted in: TG Swap)

tailgate re-wired.gif
906 hits | 13.44 KB | Posted: 11/30/03
(Posted in: TG Swap)

original_connectors.jpg
763 hits | 4.9 KB | Posted: 12/1/03
Original Connectors
(Posted in: TG Swap)

new_connectors1.JPG
864 hits | 81.74 KB | Posted: 12/1/03
New Connectors
(Posted in: TG Swap)

new_connectors2.jpg
900 hits | 51.65 KB | Posted: 12/1/03
New Connectors
(Posted in: TG Swap)

new_wiring1.jpg
795 hits | 41.38 KB | Posted: 12/1/03
(Posted in: TG Swap)

new_wiring2.jpg
728 hits | 83.96 KB | Posted: 12/1/03
(Posted in: TG Swap)

new_wiring3.jpg
780 hits | 72.47 KB | Posted: 12/1/03
(Posted in: TG Swap)

tailgate_relays.jpg
805 hits | 48.79 KB | Posted: 12/1/03
2 of these relays on the inner quatrer panel are for the tailgate window motor
(Posted in: TG Swap)

charge1.jpg
827 hits | 75.34 KB | Posted: 11/19/03
(Posted in: Jason Henry Harness)

harness1.jpg
908 hits | 96.16 KB | Posted: 11/19/03
(Posted in: Jason Henry Harness)

charge2.jpg
748 hits | 70.27 KB | Posted: 11/19/03
(Posted in: Jason Henry Harness)

charge3.jpg
760 hits | 82.85 KB | Posted: 11/19/03
(Posted in: Jason Henry Harness)