|
|
 New style PS Pump Front.JPG | Hits: 1467 | Size: 121.99 KB | Posted on: 10/11/04 | Link to this image
Saginaw pump is out of a Chevy 1 ton van and rebuilt by a pro. This pump requires a seperate resivoir.
|
|
|
 New Style PS Pump Rear.JPG | Hits: 1284 | Size: 114.78 KB | Posted on: 10/11/04 | Link to this image
Rear view of pump.
|
|
|
 Sag bracket out of van front.JPG | Hits: 1221 | Size: 119.38 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 Sag bracket out of van rear.JPG | Hits: 1129 | Size: 112.8 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 Sag bracket out of van with new pump front.JPG | Hits: 1153 | Size: 109.85 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 Sag bracket out of van with new pump side.JPG | Hits: 1140 | Size: 109.28 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 New pump and bracket in truck top front.JPG | Hits: 1189 | Size: 107.52 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 New pump and bracket with AC installed.JPG | Hits: 1131 | Size: 105.44 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 With PS resivoir installed.JPG | Hits: 1270 | Size: 113.36 KB | Posted on: 10/11/04 | Link to this image
The resivoir is out of a Chevy econo box. Lots of vehicles use a resivoir. If I had it to do over again I would get one out of a Chevy-20 van or BMW. Both have more capacity.
|
|
|
 Top view with hoses installed.JPG | Hits: 1164 | Size: 118.09 KB | Posted on: 10/11/04 | Link to this image
|
|
|
 PS cooler installed.JPG | Hits: 1141 | Size: 119.72 KB | Posted on: 10/11/04 | Link to this image
|
|
|
Picture of the two pulleys that you will usually find on a Saginaw pump. The one on the left is from a Ford e-350 van. The one on the right is one you usually find on GM vehicles.
|
|
|
 two pulleys big one measured.jpg | Hits: 1118 | Size: 82.62 KB | Posted on: 4/27/05 | Link to this image
The two pulleys again. The GM pulley measures 6.5" diameter. The center hole is .755".
|
|
|
 two pulleys small one measured.jpg | Hits: 978 | Size: 84.72 KB | Posted on: 4/27/05 | Link to this image
The pulley on the left is off of an E-350 van Saginaw pump. It is 5.75" in diameter with the .755 diameter hole. The 5.75" is the same size you will find on the Ford C-2 PS pump. I forget the diameter of the C-2 shaft but it is about .665 or so.
|
New Saginaw Pump