|
|
Hits: 713
Size: 55.03 KB
Posted: 5/18/05
97 10.25 Sterling rear axle, out of an f350. Has since been rebuilt with Yukon 4.88 gears (long pini... | 
Hits: 694
Size: 43.22 KB
Posted: 6/6/05
axle in | 
Hits: 731
Size: 45.57 KB
Posted: 6/6/05
| 
Hits: 861
Size: 30.4 KB
Posted: 6/6/05
Not the greatest shackle angle..may correct that soon
This is with a 2" belltech lowering shackle | 
Hits: 714
Size: 49.99 KB
Posted: 6/7/05
bracket-be gone
Had to clearence the body a bit with a torch to get access at the top bolts, and ... |
Hits: 652
Size: 39.82 KB
Posted: 6/7/05
| 
Hits: 687
Size: 37.88 KB
Posted: 6/7/05
How much room you have available to move your axle forward without moving the bracket vertically up ... | 
Hits: 713
Size: 34.22 KB
Posted: 6/7/05
Bracket tacked in place, comparison to stock holes | 
Hits: 872
Size: 42.97 KB
Posted: 6/7/05
bottom hole is 3" back, and a smidgen lower on the frame (this is to negate the lift lost by moving ... | 
Hits: 598
Size: 49.38 KB
Posted: 6/7/05
Top hole about 2.5" from old hole, and a tad lower |
Hits: 635
Size: 38.01 KB
Posted: 6/7/05
Bracket in relation to stock crossmember rivet, and bottom of frame
From frame to bottom of the b... | 
Hits: 717
Size: 43.59 KB
Posted: 6/7/05
can barely get a socket on there, but will be enough to tighten it down, although that could easily ... | 
Hits: 659
Size: 33.41 KB
Posted: 6/7/05
shackle angle without any weight on it | 
Hits: 594
Size: 41.66 KB
Posted: 6/7/05
axle with weight on it, moved 3" back | 
Hits: 664
Size: 24.49 KB
Posted: 6/7/05
Shackle angle with weight on it (not TOO bad, but still a lil verticle for my taste, the rear shackl... |
Hits: 648
Size: 32.69 KB
Posted: 6/7/05
pinion angle still pretty good ;) | 
Hits: 913
Size: 43.63 KB
Posted: 6/7/05
better pinion angle shot | 
Hits: 616
Size: 25.66 KB
Posted: 6/7/05
stock axle marking (center of hub), to current marking on right (center of hub), 3" | 
Hits: 641
Size: 21.7 KB
Posted: 6/7/05
47" to the top of my fenders :) | 
Hits: 679
Size: 43.15 KB
Posted: 6/7/05
Tire in relation to hight of vehicle/fender cutting
with Approx. 7" of lift |
97 10.25 Sterling Swap