JoeBob1901 > 1995 Ford Bronco > open folder 97 10.25 Sterling Swap

97 10.25 Sterling rear axle, out of an f350. Has since been rebuilt with Yukon 4.88 gears (long pini...
Url
Tag
Img
Thumb
axle in
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
Not the greatest shackle angle..may correct that soon This is with a 2" belltech lowering shackle
Url
Tag
Img
Thumb
bracket-be gone Had to clearence the body a bit with a torch to get access at the top bolts, and ...
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
How much room you have available to move your axle forward without moving the bracket vertically up ...
Url
Tag
Img
Thumb
Bracket tacked in place, comparison to stock holes
Url
Tag
Img
Thumb
bottom hole is 3" back, and a smidgen lower on the frame (this is to negate the lift lost by moving ...
Url
Tag
Img
Thumb
Top hole about 2.5" from old hole, and a tad lower
Url
Tag
Img
Thumb
Bracket in relation to stock crossmember rivet, and bottom of frame From frame to bottom of the b...
Url
Tag
Img
Thumb
can barely get a socket on there, but will be enough to tighten it down, although that could easily ...
Url
Tag
Img
Thumb
shackle angle without any weight on it
Url
Tag
Img
Thumb
axle with weight on it, moved 3" back
Url
Tag
Img
Thumb
Shackle angle with weight on it (not TOO bad, but still a lil verticle for my taste, the rear shackl...
Url
Tag
Img
Thumb
pinion angle still pretty good ;)
Url
Tag
Img
Thumb
better pinion angle shot
Url
Tag
Img
Thumb
stock axle marking (center of hub), to current marking on right (center of hub), 3"
Url
Tag
Img
Thumb
47" to the top of my fenders :)
Url
Tag
Img
Thumb
Tire in relation to hight of vehicle/fender cutting with Approx. 7" of lift
Url
Tag
Img
Thumb

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog