step 1: place vehicle on jack stands.

rt front hub and rotor

lt ft hub and rotor.

2nd photo before disassembly of rt frt hub and rotor

disassembly of rt side.

rt hub...looks like i had a water leak...completely saturated in dirt and oil...not sure whether to clean or replace...if replace will have good one from left side as spare.

left side after disassembly

2nd shot of left side

close up of left side.

Third member removed from vehicle...will clean and paint since I have it out.

no spider gears in it.

Aussie locker components before install.

All cleaned up and ready for install of locker.

With aussie locker installed...just have to check tolarances...calls for between.145 - .170.

carrier back in housing.

front axles before clean up and new u joint installation.

aussie locker in carrier

another shot of locker in carrier.

front view of carrier back in housing.

side shot of carrier in housing.

front drive line with third member out.

rr shot of center diff.

another shot of front end.

another angle.

front view.

drive axles all clean and repainted.

2nd shot of frt axles waiting for reassembly...just waiting for new u-joints, bearings and seals to come in from Randys Ring and Pinion.