The electric fan controller, Advance Auto Parts Imperial/Hayden part # 226204
Url
Tag
Img
Thumb
I walked down all the rows of Ford cars looking for a Mark VIII to get the fan from, as I've heard i...
Url
Tag
Img
Thumb
1998 Thunderbird. This pic shows the depth of the electric fan into the engine bay, and kind of what...
Url
Tag
Img
Thumb
Theres a 1994 t-bird next to it with 30k miles more than the 1998. I took the newer one with less mi...
Url
Tag
Img
Thumb
All the stuff I have amassed so far for the swap, and the Taurus fan. 16 inches. Hard to see but I p...
Url
Tag
Img
Thumb
Taurus fan: 22 inches across
Url
Tag
Img
Thumb
Taurus fan: 17 inches vertical
Url
Tag
Img
Thumb
Taurus fan: About 5 inches deep
Url
Tag
Img
Thumb
T-bird fan. Also 22 inches across, and since its square, its about 22 inches vertical
Url
Tag
Img
Thumb
T-bird fan: About 5 inches deep.
Url
Tag
Img
Thumb
All my stuff. A new quality pair of wire cutters/strippers/crimpers from Grainger, project box, grom...
Url
Tag
Img
Thumb
T-bird fan 18 inches across
Url
Tag
Img
Thumb
Remove the 4 fan bolts...
Url
Tag
Img
Thumb
It might take some persuasion depending on how long its been on, but mine came off easy, only been o...
Url
Tag
Img
Thumb
Thread the fan bolts back in. These also hold the outer water pump pulley on.
Url
Tag
Img
Thumb
T-bird fan held in place. There is very little room, 1-2 mm between the motor and the pulleys...not ...
Url
Tag
Img
Thumb
Top down view, you can see its too deep to fit. This is most likely due to the extremely large radia...
Url
Tag
Img
Thumb
Taurus fan fits perfectly. Not sure why there is a difference, When I measured the thickness of the ...
Url
Tag
Img
Thumb
I held it to the drivers side of the radiator, I'm not sure it really matters where on the radiator ...
Url
Tag
Img
Thumb
Held in the middle of the radiator, it's close but no interference. I guess I dont know how to use a...
Url
Tag
Img
Thumb
Not content to use the smaller Taurus fan, I decided to cut a little bit of the shroud off the T-bir...
Url
Tag
Img
Thumb
Flush with the drivers side of the radiator, there is now enough clearance to mount it, and allow fo...
Url
Tag
Img
Thumb
Cut the mounting tab off the side of it. The tab was pushing the fan off the radiator a bit allowing...
Url
Tag
Img
Thumb
This is a blue/white wire to either  the EEC or Fuel Pump relay.
It is the most convenient tie-in I...
Url
Tag
Img
Thumb
This is the yellow wire from the fan controller that ties into the IGN ON blue/white wire by the FP/...
Url
Tag
Img
Thumb
This is where the project box is going. I'm leaving it open until I tweak everything and confirm eer...
Url
Tag
Img
Thumb
I didnt have any heat shrink this big so I had to resort to electrical tape. This is the splice into...
Url
Tag
Img
Thumb
The 300 amp continuous duty solenoid. Way overkill, and hindsight and some more research shows I cou...
Url
Tag
Img
Thumb
Temperature probe installed right next to the inlet coolant hose. Its a nice tight fit, I cant imagi...
Url
Tag
Img
Thumb
This is the tie-in for the green AC ON wire to the fan controller. This tells the fan to come on eve...
Url
Tag
Img
Thumb
This is where I routed the wires for the fan. Gonna put split hose on it when I get around to it.
Url
Tag
Img
Thumb
Bottom up view of the routing of my fan wires.
Url
Tag
Img
Thumb
Dual Taurus fans mounted. This took some shroud cutting, and the are about as close to each other as...
Url
Tag
Img
Thumb
Using cardboard to make a template to cut the shroud of the dual fans around the radiator hoses etc.
Url
Tag
Img
Thumb
layed over the fans I can see where I have to cut.
Url
Tag
Img
Thumb
It took alot of test fitting and trimming and more test fitting. About an hour of this and I had a g...
Url
Tag
Img
Thumb
My wiring job. Not sure I like it, not waterproof enough but its good for now until I do a massive r...
Url
Tag
Img
Thumb
A simple 1 inch wide piece of aluminum I bent to follow the countours of the fan shrouds. This is st...
Url
Tag
Img
Thumb
Url
Tag
Img
Thumb
 

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog