Meixter > 1991 Ford Bronco > open folder Front Gear/Locker Install

Getting the jack stands placed.
Url
Tag
Img
Thumb
Stock open 3rd member
Url
Tag
Img
Thumb
Here's the 'C' clip that I won't be needing anymore
Url
Tag
Img
Thumb
Ring gear and carrier out
Url
Tag
Img
Thumb
Pulling the carrier bearing to make a set up bearing out of it
Url
Tag
Img
Thumb
Cookie is very excited
Url
Tag
Img
Thumb
Pinion gear, races and bearings removed
Url
Tag
Img
Thumb
New 4.56 ring gear on new ARB locker :-)
Url
Tag
Img
Thumb
Pressing a carrier bearing on
Url
Tag
Img
Thumb
Checking backlash for first gear pattern check
Url
Tag
Img
Thumb
Had to make an adjustment
Url
Tag
Img
Thumb
Here's the final pattern on the drive side. I hope it's right.
Url
Tag
Img
Thumb
Here's the coast pattern
Url
Tag
Img
Thumb
Case all cleaned up. New bearings installed. Ready for final assembly
Url
Tag
Img
Thumb
New pinion nut and seal
Url
Tag
Img
Thumb
Filling a notch in the bearing cap for the air line to the locker
Url
Tag
Img
Thumb
Took me a minute to figure out how I was going to bend this into the case
Url
Tag
Img
Thumb
Here it is with the bulkhead fitting on the top of the case
Url
Tag
Img
Thumb
I am pretty happy with how it turned out.
Url
Tag
Img
Thumb
3rd member back in.
Url
Tag
Img
Thumb
This cap needs to be tack welded so the spring I have to add in the slip yoke won't pop it out.
Url
Tag
Img
Thumb
Break out the wire feed
Url
Tag
Img
Thumb
I'm not a master welder yet but I think it'll hold
Url
Tag
Img
Thumb
Here's how I routed the air line.
Url
Tag
Img
Thumb
While I had it out I installed this drain plug
Url
Tag
Img
Thumb

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog