Rubicon 009.jpg 1059 hits | 60.62 KB | Posted: 6/1/04 the angle of the hose was not allowing it to hold in, so i used a 90* bend to get it right. (Posted in: Extended Breather Lines)
P2070017.JPG 1059 hits | 60.45 KB | Posted: 2/9/04 (Posted in: Front 3rd member and D50 stub shaft install)
DSCF0394.JPG 1058 hits | 95.8 KB | Posted: 7/18/04 my 14 bolt no longer has a fat lip :-D (Posted in: 1 ton upgrade)
14 bolt 006.jpg 1058 hits | 60.97 KB | Posted: 8/1/04 rear shock mount #1 (Posted in: 1 ton upgrade)
1950 chevy stepside 2.jpg 1058 hits | 46.08 KB | Posted: 8/6/05 its all org all it would need to dr right now is gas and a batt but wont go over 35 mph (Posted in: other trucks my dad and i have)
139_3947.JPG 1056 hits | 61.7 KB | Posted: 9/20/04 (Posted in: Got it on the ramp)
shaftage 010.jpg 1056 hits | 65.08 KB | Posted: 11/30/07 use the male spline to line up the yokes before you weld them. (Posted in: Long Travel Driveshaft)
my truck 1.jpg 1056 hits | 15.4 KB | Posted: 7/17/05 1 (Posted in: my bronco)
Rubicon 008.jpg 1054 hits | 56.75 KB | Posted: 6/1/04 i used some random silicone i had laying around, but it didn't hold. i ended up using krazy glue, which believe it or not worked. (Posted in: Extended Breather Lines)
139_3952.JPG 1054 hits | 57.03 KB | Posted: 9/20/04 (Posted in: Got it on the ramp)
DSCF0625.JPG 1054 hits | 36.29 KB | Posted: 12/31/04 the jackass stole an excavator apparently, dug a huge hole and then drove the tractor into the hole (Posted in: Fordyce Creek & Mormon Emigrant Road snow wheeling)
DSC02099a.jpg 1053 hits | 71.13 KB | Posted: 12/5/04 I think this is clearanced enough. I may make an aluminum plate to clean up the area a bit. (Posted in: New Exhaust)
