inside driver #1bracket.jpg 3141 hits | 42.31 KB | Posted: 8/20/04 rough plan for the front crossmember (Posted in: D60 front)
DSCF0438.JPG 3311 hits | 63.72 KB | Posted: 8/21/04 mockup of the crossmember. spring perches will be welded to the bottom of it. (Posted in: D60 front)
DSCF0441.JPG 4047 hits | 67.71 KB | Posted: 8/23/04 DRW hubs vs. SRW hubs. the dually hubs add about 5" of width per side compared to the single wheel ones. and no, i will not be running the dually setup. (Posted in: D60 front)
DSCF0442.JPG 3254 hits | 72.31 KB | Posted: 8/23/04 grinding and beating off the old trac bar mount. (Posted in: D60 front)
DSCF0443.JPG 3325 hits | 71.16 KB | Posted: 8/23/04 notch cut into the webbing for u-bolt flip (Posted in: D60 front)
DSCF0439.JPG 3076 hits | 68.37 KB | Posted: 8/23/04 60 shaft vs a TTB 44 shaft (Posted in: D60 front)
DSCF0440.JPG 3039 hits | 73.91 KB | Posted: 8/23/04 notice how small the 44 shaft necks down too. i'm not sure if a solid 44 shaft does this as well, but the difference in shaft size is significant. (Posted in: D60 front)
DSCF0447.JPG 3223 hits | 38.4 KB | Posted: 8/25/04 where the fins on the crossmember will go (Posted in: D60 front)
DSCF0448.JPG 3111 hits | 38.92 KB | Posted: 8/25/04 same thing, other side (Posted in: D60 front)
DSCF0498.JPG 3920 hits | 54.34 KB | Posted: 9/2/04 turn your head, front shock mount. left over from TTB lower and stock f250 upper (Posted in: D60 front)
DSCF0499.JPG 5898 hits | 68.5 KB | Posted: 9/2/04 looks right at home (Posted in: D60 front)
DSCF0500.JPG 5647 hits | 70.28 KB | Posted: 9/2/04 stock f350 rear hanger moved forward and a shot of the shackle angle (Posted in: D60 front)
DSCF0501.JPG 3864 hits | 56.67 KB | Posted: 9/2/04 rear pinion angle is fubared after shackle flip, only because when the 14 bolt was installed, we took out the angle wedges and set the pinion angle right. the shackle flip is designed to do the same thing. OFW, its an easy fix. (Posted in: D60 front)
DSCF0502.JPG 5799 hits | 57.08 KB | Posted: 9/2/04 Sky Manufacturing shackle flip kit. the flip is good for about 4.5" of lift. its uber easy to install too. (Posted in: D60 front)
