6-25-2007-32.jpg
1397 hits | 73.21 KB | Posted: 6/25/07
CAGE arms crossmember
(Posted in: 78saxle)

DSCF0927.JPG
1397 hits | 60.46 KB | Posted: 7/7/05
(Posted in: Cage)

PA100040.JPG
1396 hits | 44.64 KB | Posted: 10/10/04
loose your visors due to having a cage? simple solution is buying some maglite flashlight holders and mounting them to your visor. then just snap it on when you need to use it.
(Posted in: Roll Cage)

DSCF0014.JPG
1395 hits | 98.22 KB | Posted: 9/1/06
Richfield Utah
(Posted in: 78saxle)

PB240002.JPG
1394 hits | 82.67 KB | Posted: 11/24/03
new and improved...added a support between the crossmember and t-case. I can jack up the truck off the skid with minimal flexing.
(Posted in: Skid Plate)

DSCF0080.JPG
1393 hits | 66.16 KB | Posted: 3/14/04
(Posted in: TTB bracket shots)

PB130104.JPG
1392 hits | 75.6 KB | Posted: 11/13/03
(Posted in: Skid Plate)

PA100041.JPG
1391 hits | 47.55 KB | Posted: 10/10/04
also works for mounting a GPS
(Posted in: Roll Cage)

IMG_3874 (Small).JPG
1390 hits | 47.95 KB | Posted: 12/11/04
(Posted in: Dana 60 Swap #2 with springs)

DSCF0079.JPG
1389 hits | 61.32 KB | Posted: 3/14/04
(Posted in: TTB bracket shots)

P7090186.JPG
1387 hits | 63.46 KB | Posted: 7/9/06
(Posted in: Rear Prerunner bumper)

DSCF0002.JPG
1384 hits | 95.54 KB | Posted: 10/3/06
Midvale Utah
(Posted in: 78saxle)

sagyork2.JPG
1380 hits | 45.57 KB | Posted: 6/29/03
using 1.5" spacers you are able to get the york high enough to clear the pump
(Posted in: Saginaw swap)

mhub-01.jpg
1378 hits | 103.73 KB | Posted: 2/20/07
(Posted in: warn hubs)

P2250159.JPG
1377 hits | 81.15 KB | Posted: 2/25/07
(Posted in: forsale)

P side bracket 1.jpg
1376 hits | 55.07 KB | Posted: 2/11/04
beginnings of the passenger side
(Posted in: Coilover setup)

005_psfull.JPG
1375 hits | 38.89 KB | Posted: 5/2/04
(Posted in: It's on)

002_crossmember.JPG
1372 hits | 36.51 KB | Posted: 5/2/04
(Posted in: It's on)

P1010091.JPG
1371 hits | 73.32 KB | Posted: 12/14/04
(Posted in: Front Bumper and Recovery Points)

Pismo_014.jpg
1370 hits | 15.84 KB | Posted: 6/30/03
Pulling out a stuck Ram 1500 with a 6" lift and 35" X-Terrains with my stocker.
(Posted in: Oceano Dunes 6/21/03)

frame9.jpg
1370 hits | 23.87 KB | Posted: 4/7/04
(Posted in: Frame by frame of the infamous jump...)

ban-cha.gif
1368 hits | 60.22 KB | Posted: 12/19/07
(Posted in: more junk feb06 on)

DSC00438.JPG
1367 hits | 81.49 KB | Posted: 11/17/04
(Posted in: Coilover flex pics - NEW!)

DSCF0926.JPG
1367 hits | 66.11 KB | Posted: 7/7/05
(Posted in: Cage)

P3130014.JPG
1363 hits | 49.6 KB | Posted: 3/14/05
(Posted in: Roll Cage)

P2070007.JPG
1363 hits | 56.76 KB | Posted: 2/9/04
(Posted in: Front 3rd member and D50 stub shaft install)

PB160108.JPG
1362 hits | 54.19 KB | Posted: 11/16/03
This skid isnt going to go anywhere and it sits much higher than stock to aid in some much needed clearence
(Posted in: Skid Plate)

P1260039.JPG
1361 hits | 72.46 KB | Posted: 1/26/04
(Posted in: Roll Cage)

domelight.JPG
1360 hits | 48.18 KB | Posted: 1/26/05
(Posted in: Dome Light Mod)

DSCF0520.JPG
1360 hits | 47.07 KB | Posted: 9/29/04
seats from an 88 Saab 5000 Turbo. $100 and 10 minutes at the junkyard for the set.
(Posted in: Project Bling Bling)

DSCF0931.JPG
1359 hits | 56.27 KB | Posted: 7/7/05
(Posted in: Cage)

P7160190.JPG
1356 hits | 52.12 KB | Posted: 7/16/06
(Posted in: Rear Prerunner bumper)

bw06.jpg
1355 hits | 57.54 KB | Posted: 2/27/05
(Posted in: flares)

DSCF0581.JPG
1354 hits | 46.18 KB | Posted: 11/26/04
temporary setup till i get some free time to make a new bumper
(Posted in: Front Bumper and Recovery Points)

Image064.jpg
1353 hits | 28.31 KB | Posted: 2/24/07
(Posted in: MISC PICS)

PB130103.JPG
1350 hits | 55.88 KB | Posted: 11/13/03
(Posted in: Skid Plate)

P2250160.JPG
1350 hits | 51.89 KB | Posted: 2/25/07
(Posted in: forsale)

frame10.jpg
1349 hits | 25.84 KB | Posted: 4/7/04
(Posted in: Frame by frame of the infamous jump...)

P7090187.JPG
1348 hits | 54.01 KB | Posted: 7/9/06
(Posted in: Rear Prerunner bumper)

P8260005.JPG
1348 hits | 74.44 KB | Posted: 8/26/06
(Posted in: Rear Prerunner bumper)

PB160110.JPG
1347 hits | 59.56 KB | Posted: 11/16/03
there is a little kick up in front to help prevent snaging on rocks
(Posted in: Skid Plate)

DSCF0591.JPG
1346 hits | 72.06 KB | Posted: 12/5/04
finished product. very simple to bolt in, you just need a 7 degree tapered tie rod reamer to enlarge the holes since Ford tie rod ends are much smaller.
(Posted in: 1 ton steering)

mount panel.gif
1344 hits | 9.39 KB | Posted: 1/15/04
(Posted in: technical pics)

006_psclose.JPG
1344 hits | 42.56 KB | Posted: 5/2/04
(Posted in: It's on)

4-4-2007-10.jpg
1344 hits | 81.88 KB | Posted: 6/22/07
Bronco High Steer
(Posted in: 78saxle)