Upper and Lower intake manifolds, Injectors, fuel rails and Injector wiring

Wiring harness, Distributor, air box etc.

Close up of connectors needed to be removed on fire wall.

Round - Connects to the fuse panel on the inside
Rectangular - Connects to the EFI computer in driverside kick panel

Close up of Distributor

Not sure what this is, but it said Heavy Duty and he said I could take it.

Computer and mounting bracket for inside driverside kick panel.

I got lucky and the Tranny in this truck was a C6 so I shouldnt' have any problems at all with the computer.

'86 EFI in tank pump

Here's is Where Mike put my O2 sensor. Nice and easy to get to if it goes out.

Located the computer in side the factory Tool box that came with the early 80s broncos as an option.

Full shop of the EFI installed. It's a little messier then the Carb set up I had. But I think I'll deal with it.

Left side of the engine compartment. Mike Located the Vacuum box over there.

Right side of the engine compartment. Located here are the relays, ignition module and computer.

Close up of the modules and computer box..

Y-pipe I had to have made, because I swapped in a '93 Exhaust manifold.

F250 pump(White) next to a Bronco pump(tan).