Original guage panel. I didn't cut this one up, but this is what the one I used started out looking like(Minus the vents.)

Panel cut to allow for new gauges and switches

New guage panel cut, and drilled test fitting on original panel.
Holds
2 - 3-3/8 gauges
5 - 2-1/16 guages
7 - 1/2" switches (on-off)
1 - 1/2" Light
1 - 1/2" on-off-on momentary switch

Gauges test fit in new panel on the old panel

Inner panel that the factory gauges connect too. Trimmed to accept all the new gauges.

Bottom view of the same panel. I removed the lower portions to allow for extra wires to be run.

Front of new Gauge cluster bolted up and ready to wire.

Rear shot with all the wiring for the gauges.