Img_0295.jpg 1757 hits | 62.18 KB | Posted: 3/8/04 Started November 29th, 2003... (Posted in: 460 project)
snowtruck1.JPG 1755 hits | 15.76 KB | Posted: 6/29/03 This is January in South Carolina (Posted in: The Bronco)
9in drain.jpg 1753 hits | 62.62 KB | Posted: 8/11/03 I added a drain to the 9inch so I don't have to crack the third member to change the gear oil after the gear break-in. Plus more oil will drain out the hole plug than could drain from the bottom of the third member openning. There is a magnet in the... (Posted in: Modifications)
rear_dr_.JPG 1752 hits | 28.77 KB | Posted: 6/29/03 OK, so here's the secret. This is the driver's side rear spring, viewed from the front. The sping rocker is pivoting. This spring is under NO pressure. (Posted in: Spring Rockers)
IMAG0025.JPG 1739 hits | 83.39 KB | Posted: 8/17/03 now look had to use four wheele drive here (Posted in: elephent butte camping)
Img_0297.jpg 1736 hits | 58.1 KB | Posted: 3/8/04 Since Ned had to leave to go to the Panthers game, I had to get it out myself. Due to me taking shortcuts I left the exhaust manifolds connected to the Y pipe figuring they would slide off the block...they didnt, and it took forever to get the motor ... (Posted in: 460 project)
broncsky.jpg 1734 hits | 40.17 KB | Posted: 6/29/03 Top 'o the hill. (Posted in: Kennesaw Hill)
DCP_0331.jpg 1733 hits | 59.55 KB | Posted: 9/28/03 Removing Pulley & Clutch.
After removing the center bolt, drive in a 5/8" - 11 bolt to pull the assembly off the shaft.
(8/26/2003) (Posted in: On Board Air Compressor)
fueltank.jpg 1732 hits | 45.9 KB | Posted: 6/29/03 fuel tank mounting. Keith L loves to imporve and rant on the factory quality (Posted in: Fuel System)