dcp_2773.JPG
1707 hits | 95.38 KB | Posted: 3/17/06
(Posted in: bronco)

013-winched-Anne-out.JPG
1706 hits | 85.63 KB | Posted: 12/15/03
(Posted in: Mt.Hood Xmas Tree 2003-12-13)

DCP_0347.jpg
1704 hits | 72.85 KB | Posted: 9/28/03
Compressor mounted (above view) & the Bronco Air serp/v-groove power steering pump combo pulley.
(9/28/2003)
(Posted in: On Board Air Compressor)

bronco delrio.jpg
1702 hits | 32.43 KB | Posted: 3/5/04
Dle Rio, Rough Canyon run
(Posted in: Minister)

GaugeCloseUpPic#2.JPG
1702 hits | 55.54 KB | Posted: 3/26/04
Close Up pic of Autometer 2 5/8" Water Temp and Oil Pressure gauges.
(Posted in: Gauges)

trk1.jpg
1702 hits | 55.54 KB | Posted: 6/30/03
(Posted in: Truck pics)

Pict0007.JPG
1701 hits | 26.12 KB | Posted: 6/29/03
another view of the same rig
(Posted in: Friday Trail Ride)

rear_ps.JPG
1700 hits | 25.07 KB | Posted: 6/29/03
LOOK AT THIS: The passenger side 4" spring is under SO much pressure that it is arching in REVERSE. The rocker has pivoted about as FAR as it can go!
(Posted in: Spring Rockers)

DCP_0737.jpg
1699 hits | 52.22 KB | Posted: 6/23/05
Grease Fitting to Cavity Behind the Center Ball
7/32" Drill Bit & 1/4" - 28 Tap
(Posted in: Driveshaft)

Mt Hood - Hood River - Mt Defiance Trail - Rock #1 - Alvey.wmv
1699 hits | 8.12 MB | Posted: 6/29/11
(Posted in: Hood River (6/25/2011))

juice11_big.jpg
1697 hits | 20.69 KB | Posted: 1/20/07
(Posted in: My Mods)

saginaw_brackets.jpg
1697 hits | 26.03 KB | Posted: 6/29/03
Saginaw bracket on the Left, found on vans. Or part # F4UZ3C511A for around $45-$50 at your local Dealer
(Posted in: Saginaw swap)

PICT0130.JPG
1696 hits | 49.3 KB | Posted: 12/24/04
Me and Darryl Worley at Bagram AF, Afghanistan.
(Posted in: Afghanistan)

[email protected]_Eagle_Ridge_006.mpg
1693 hits | 15.95 MB | Posted: 12/29/07
(Posted in: December 29-07 @ Eagle Ridge)

20060520-4 - Long Beach - Seagulls Dive Bombing Eagle (HQ).wmv
1693 hits | 4.12 MB | Posted: 7/11/06
(5/20/2006)
(Posted in: Long Beach, WA (2006))

Img_0321.jpg
1692 hits | 79.03 KB | Posted: 3/8/04
Puttin her back together...
(Posted in: 460 project)

controlarm01.jpg
1692 hits | 40.7 KB | Posted: 6/30/03
arm w/o brackets
(Posted in: Extended radius arms)

DCP_0381.jpg
1691 hits | 54.74 KB | Posted: 10/25/03
(Posted in: Miscellaneous)

Glacier Monkey.wmv
1691 hits | 1.65 MB | Posted: 2/25/04
(Posted in: Richloam 2/22/04)

Mt Hood - Hood River - Mt Defiance Trail - Rock #2 - Alvey.wmv
1690 hits | 3.82 MB | Posted: 6/29/11
(Posted in: Hood River (6/25/2011))

Img_0314.jpg
1689 hits | 71.63 KB | Posted: 3/8/04
We made a mess....but we're done with the cherry picker at least...
(Posted in: 460 project)

dcp_2773.JPG
1686 hits | 92.92 KB | Posted: 3/11/06
(Posted in: bronco)

Img_0334.jpg
1686 hits | 80.8 KB | Posted: 3/8/04
AC compresser is gonna sit on top until I get a AC/PS bracket...to make a long story short I didnt have a Sag bracket and wanted one to use my sag pump.
(Posted in: 460 project)

DCP_0905.jpg
1685 hits | 49.97 KB | Posted: 4/30/06
A/C Compressor On Signal
The A/C compressor on signal is sourced from the pressure switch connector.
Since this is a non critical signal, about 1-1/2 to 2 inches of insulation was removed to allow the bare wire to be sandwiched into the connector. ...
(Posted in: Electric Cooling Fan)

Exhaust_08.JPG
1684 hits | 46.72 KB | Posted: 7/25/03
(Posted in: Exhaust)

Soft_Top_24.jpg
1683 hits | 68.31 KB | Posted: 9/23/03
(Posted in: Soft Top)

Img_0309.jpg
1681 hits | 70.23 KB | Posted: 3/8/04
Its dead....
(Posted in: 460 project)

Exhaust_05.JPG
1680 hits | 50.48 KB | Posted: 7/25/03
(Posted in: Exhaust)

pinion_angle_3.jpg
1680 hits | 44.2 KB | Posted: 6/29/03
One more picture, maybe this is better than the other 2, I dunno..
(Posted in: Shackle flip)

centpsr[1].jpg
1680 hits | 57.8 KB | Posted: 7/6/03
(R) REAR
(Posted in: 1986 CENTURION)

Img_0299.jpg
1678 hits | 69.87 KB | Posted: 3/8/04
She's out! And a little lighter in the front end too!
(Posted in: 460 project)

Sliders Sketch.JPG
1677 hits | 20.47 KB | Posted: 11/11/03
Rough Sketch.

Main Slider: 1-1/2" x 4" x 1/8"
Mounting Arms, Outer Rail and Spacers: 1-1/2" x 1-1/2" x 1/8"
Mounting Plates: 3/16" Plate

(Posted in: Rock Slider Step Boards)

Paint 6.JPG
1676 hits | 68.23 KB | Posted: 11/10/03
(Posted in: Gas Tank Armor)

GaugesPic#2.JPG
1676 hits | 71.63 KB | Posted: 3/26/04
Another view of all three gauges mounted to A Pillar.
(Posted in: Gauges)

BroncoTat1.JPG
1674 hits | 47.65 KB | Posted: 3/25/06
Done March 24, 2006 @ Texas Body Art on Jones Rd Houston, TX by Ronnie.
(Posted in: Bronco Pics)

9in drain.jpg
1673 hits | 62.62 KB | Posted: 8/11/03
I added a drain to the 9inch so I don't have to crack the third member to change the gear oil after the gear break-in. Plus more oil will drain out the hole plug than could drain from the bottom of the third member openning. There is a magnet in the...
(Posted in: Modifications)

shack006.jpg
1671 hits | 57.61 KB | Posted: 8/16/03
Beefy ass shackles from 1/4" steel
(Posted in: Rear shackle flip)

09-Kenzie-Kassie-Bumpercars.jpg
1671 hits | 101.16 KB | Posted: 8/8/03
(Posted in: 08/02/03 Long Beach)

broncsky.jpg
1671 hits | 40.17 KB | Posted: 6/29/03
Top 'o the hill.
(Posted in: Kennesaw Hill)

bronco before.JPG
1670 hits | 64.51 KB | Posted: 10/7/03
(Posted in: lift)

AA_0110_023H.jpg
1669 hits | 64.51 KB | Posted: 6/30/03
Just a little difference.
(Posted in: 6" Lift install 9/02)

[email protected]_Harrison_West_25.MOV
1668 hits | 9.65 MB | Posted: 6/10/07
(Posted in: May 20-07 @ Harrison West)

enginebayafter.jpg
1667 hits | 55.99 KB | Posted: 6/30/03
Engine bay after.....
(Posted in: 460 Swap)

IMAG0038.JPG
1665 hits | 56.86 KB | Posted: 8/17/03
(Posted in: elephent butte camping)

Img_0330.jpg
1664 hits | 73.09 KB | Posted: 3/8/04
When your toolbox does not include a funnel, and you are sick of going out and buying tools you dont have, you improvise. Here, cut off one of my horns that didnt work anyway and used it to pour my transmission fluid in. Brilliant
(Posted in: 460 project)