PDRM0025.JPG 1968 hits | 20.45 KB | Posted: 3/14/06 A close up of my v8 emblem (s)
Nabbed them off the 5.0 93 t-bird soon after purchasing
They match the chrome/black Merc emblems nicely (Posted in: Exterior)
0930071804.jpg 1969 hits | 27.79 KB | Posted: 10/3/07 After some work with the dremel from the BACK SIDE, I made a square opening for the fuel door release solenoid to slide through. I used some self-tapping screws into the platic to secure it.
You will need to remove the fuel cap to fit it in/out. I... (Posted in: Remote Fuel filler door release (9/'07))
PDRM0276.JPG 1987 hits | 59.97 KB | Posted: 8/9/06 From pass dash board (Posted in: A-Pillar VDO tach and pod install (8/'06))
DSCF0095.JPG 1989 hits | 74.01 KB | Posted: 1/7/07 They aren't too noticeable from the side (Posted in: Magnaflow Oblong exhaust tips (1-04-07))
STA70360.JPG 1989 hits | 73.46 KB | Posted: 5/28/07 The floor mat looks funny as that is the 'daily driving' mat laying atop the factory one ;) (Posted in: EATC Conversion and big interior detail! 5/28/07)
STA72303.JPG 1993 hits | 61.27 KB | Posted: 5/31/09 Had to change a bulb on the face plate, the following pictures are of the EATC head unit
*Face plate disengaged (Posted in: EATC Conversion and big interior detail! 5/28/07)
Notice the floor console fitment to the tunnel (Posted in: Power 8-way passenger seat)
stangnight.JPG 1996 hits | 15.69 KB | Posted: 2/18/08 Night shot (Posted in: Custom bezel #2 and new overlays)
STA72519.JPG 1997 hits | 68.18 KB | Posted: 6/27/09 MOST of my Merc's factory-included documentation / booklets. I had this displayed in the backseat at Carlisle this year and took a picture while putting it all back /organizing it at home.
Pictured: 1996 Grand Marquis brochure 1996 Mercury Vehicles ... (Posted in: 1996 Grand Marquis - See subfolders!! )
2003tcheadandfoglamps.jpg 2020 hits | 36.19 KB | Posted: 1/29/08 2003- Town Car head and fog lamp wiring (Posted in: Panther LCM / lighting circuits and pinouts)
STA70618.JPG 2027 hits | 52.13 KB | Posted: 7/17/07 I was left with a hole from the old manual recline lever.
To solve that, I used a color-matched push pin in the hole. Works alright.
You can still see the worn area of material where the handle was, but oh well. (Posted in: Power 8-way passenger seat)
STA71629.JPG 2027 hits | 52.38 KB | Posted: 2/18/08 (Posted in: Custom bezel #2 and new overlays)
STA72304.JPG 2031 hits | 74.21 KB | Posted: 5/31/09 Had to change a bulb on the face plate, the following pictures are of the EATC head unit
*A snap of the wiring for the conversion.
The extra wires in the loop on left are for currently un-used features (ie redundant audio controls and english/... (Posted in: EATC Conversion and big interior detail! 5/28/07)
