t45swap3.jpg
10146 hits | 23.47 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

OilSender1.JPG
10039 hits | 79.49 KB | Posted: 3/31/05
The older oil pressure sender uses the same thread as the later oil pressure switch, so swapping is easy. There's just enough room for it to fit. See this pic:
[url=http://www.supermotors.net/registry/media/281470][img]http://www.supermotors.net/g...
(Posted in: 2000 Engine Installation)

18TiltLever.JPG
10034 hits | 29.86 KB | Posted: 1/28/06
Reinstall the column shrouds, knee bolster, lock cylinder, & tilt lever.
(Posted in: Steering Column)

PDRM0044.JPG
10006 hits | 64.16 KB | Posted: 3/14/06
My infinity basslink sub

You can see the 12v outlet mounted under rear parcel shelf as well.

4 circuit fuse holder is behind spare tire, on the back seat frame.

AND before anyone flames me for the sub in this location due to fuel tank, the sub is ...
(Posted in: trunk power distribution / Sub / electrical)

t45swap2.jpg
9904 hits | 46.5 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

t45swap10.jpg
9767 hits | 36.55 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

19Finished.JPG
9736 hits | 45.36 KB | Posted: 1/28/06
With the key in RUN and the retainer pin pushed into the lock cylinder housing, reinsert the cylinder into the column and rotate it back to OFF to force the retaining pin out into place. Ensure that the key-in switch is in-place; the door chime shou...
(Posted in: Steering Column)

Column 96 L.JPG
9630 hits | 49.22 KB | Posted: 2/3/06
For more info, see this page:
http://www.p71interceptor.com/steering/column/disassembled/pictures

This steering column was used on almost every Ford/L/M product (and some imports) from the early 90s to today. Some of the bolt-on options changed ove...
(Posted in: Steering Column)

Column32.jpg
9557 hits | 43.05 KB | Posted: 1/28/06
This steering column was used on almost every Ford/L/M product (and some imports) from the early 90s to today. Some of the bolt-on options changed over the years, but the basic column assembly is the same. The only significant change I've found is ...
(Posted in: Steering Column)

RearSuspWattsLink.jpg
9514 hits | 62.49 KB | Posted: 1/30/05
Watts Link rear suspension '98-10 Panther chassis

1 Stabilizer bar and isolator assembly 5A771
2 Shock absorber 18125
3 Upper arm 5501
4 Lower arm 5538
5 Watts link pivot stud W704883-S428
6 Watts link pivot (Part of 4264) 5T516
7 Lateral ar...
(Posted in: Diagrams)

E-Brake.jpg
9216 hits | 76.63 KB | Posted: 3/11/07
E-brake specs.


(Posted in: E-Brake Shoes)

ParkBrake98.jpg
9154 hits | 84.02 KB | Posted: 3/19/05
Parking Brake 1998

1 -- Sound Deadener
2 -- Front Parking Brake Cable and Conduit (2853)
3 -- Parking Brake Control (2780)
4 -- Parking Brake Rear Cable and Conduit (RH) (2A635)
5 -- Parking Brake Rear Cable and Conduit (LH) (2A635)
6 -- Rea...
(Posted in: Diagrams)

EngineComponents94EVTM.jpg
9153 hits | 89.35 KB | Posted: 3/20/05
Engine Components 94 EVTM
(Posted in: Diagrams)

Column 96 R.JPG
9142 hits | 49.85 KB | Posted: 2/3/06
For more info, see this page:
http://www.p71interceptor.com/steering/column/disassembled/pictures

This steering column was used on almost every Ford/L/M product (and some imports) from the early 90s to today. Some of the bolt-on options changed ove...
(Posted in: Steering Column)

Fuses.jpg
9090 hits | 68.19 KB | Posted: 8/11/05
(Posted in: Tech)

Fuses2.jpg
9087 hits | 67.26 KB | Posted: 8/11/05
(Posted in: Tech)

96belt.jpg
8979 hits | 45.21 KB | Posted: 8/21/06
Green line represents a revised belt routing in order to *bypass* the A/C compressor. With this method, the tensioner WILL work but VERY limited - you must purchase a tight belt.

Note this is only applicable for the '93-'99 belt routing
(Posted in: TECH/MISC -- Click for MISC tech pics-SEE SUBS)

AOD ValveBody.jpg
8891 hits | 74.33 KB | Posted: 10/9/05
AOD Valve Body
(Posted in: Diagrams)

1994 CrownVic frame.JPG
8867 hits | 73.99 KB | Posted: 9/4/06
1994 Crown Vic Frame Specs
(Posted in: Diagrams)

Firing Order 94.jpg
8835 hits | 87.92 KB | Posted: 5/23/05
Firing Order & Plug Wire Routing
(Posted in: Diagrams)

EVRTest.jpg
8689 hits | 18.88 KB | Posted: 1/30/05
EVR Testing: vacuum should vent from the green line (supply port) on a good valve NOT energized. When energized, vacuum should hold from the black (source port) to the green (closer to the electrical connector).

Resistance across the terminals shou...
(Posted in: Diagrams)

HPIM0105.JPG
8234 hits | 45.85 KB | Posted: 11/8/05
Just a little organizer I made to hold some "on the fly" detailing stuff
(Posted in: 1996 Grand Marquis - See subfolders!! )

HO2S.jpg
8167 hits | 39.93 KB | Posted: 1/21/06
The heated oxygen sensor (HO2S) detects the presence of oxygen in the exhaust and produces a variable voltage according to the amount of oxygen detected. A high concentration of oxygen (lean air/fuel ratio) in the exhaust produces a low voltage signa...
(Posted in: Diagrams)

t45swap6.jpg
8160 hits | 41.3 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

cvpcm.JPG
8123 hits | 69.13 KB | Posted: 8/8/06
http://www.crownvic.net/drock96marquis/tach.htm

1996 panther plaform PCM pinout
(Posted in: Panther Electronic Engine Controls / Ignition)

03DashLoose.JPG
7930 hits | 90.85 KB | Posted: 11/11/05
There's no need to disconnect the wiring or vacuum lines on the driver's side since this provides enough access to work. With the hoses & 3 nuts already removed, the box can now be pulled from the firewall. The top stud has a push-nut holding it to...
(Posted in: Heater Core)

2005 CrownVic frame.JPG
7823 hits | 43.44 KB | Posted: 9/4/06
2005 Crown Vic Frame Specs
(Posted in: Diagrams)

PDRM0096.JPG
7750 hits | 53.94 KB | Posted: 3/24/06
LH Painted exhaust manifold
(Posted in: Engine Bay)

t45swap9.jpg
7693 hits | 29.02 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

98intFuses.JPG
7664 hits | 44.97 KB | Posted: 11/23/06
1998 Int FUse panel
(Posted in: Panther Body/Chassis/MISC diagrams and pinouts)

SpringLock Coupling.jpg
7534 hits | 49.68 KB | Posted: 3/19/05
The spring lock coupling is a fuel line coupling held together by a garter spring inside a circular cage. When the coupling is connected together, the flared end of the female fitting slips behind the garter spring inside the cage of the male fitting...
(Posted in: Diagrams)

t45swap7.jpg
7509 hits | 31.36 KB | Posted: 2/17/07
(Posted in: FunkRider's 5-speed swap)

Chicago Bears 2006 NFC Champs.jpg
7407 hits | 86.48 KB | Posted: 2/6/07
(Posted in: Chicago Bears)

AOD's 2-door 85 Crown Vic 007.jpg
7331 hits | 117.48 KB | Posted: 6/27/05
(Posted in: 85 Crown Victoria 2-Door)

STA72121b.JPG
7258 hits | 77.94 KB | Posted: 6/17/08
(Posted in: Interior Nightshots (6/'08))

Oil Flow.jpg
7246 hits | 61.46 KB | Posted: 1/2/05
Oil flow for 4.6L modular engine
(Posted in: Diagrams)

Exhaust95-up.jpg
7199 hits | 64.48 KB | Posted: 4/3/05
Exhaust 95-97

I goofed the header in the image - of course, the exhaust changed in 1998 with Watts-Link rear suspension.

Exhaust System Alignment

1. Raise and support the vehicle.
2. Check for loose, damaged, or missing heat shields. In...
(Posted in: Diagrams)

RepairLocationsCVGM.jpg
7127 hits | 42.51 KB | Posted: 3/27/05
Repair location grid for CV & GM
(Posted in: Diagrams)

CHT Sensor Graph.JPG
7117 hits | 36.03 KB | Posted: 12/4/04
CHT Sensor Graph for switching EECs

The cylinder head temperature (CHT) sensor is a thermistor device in which resistance changes with temperature. The electrical resistance of a thermistor decreases as temperature increases, and increases as temp...
(Posted in: Diagrams)

HPIM0063.JPG
7038 hits | 68.3 KB | Posted: 10/23/05
New emblems, from 1993 Ford T-bird 5.0
(Posted in: 1996 Grand Marquis - See subfolders!! )

4R70WShifter98.jpg
7032 hits | 63.43 KB | Posted: 4/3/05
4R70W Shifter Adjustment
23. From inside the vehicle, place the gearshift lever in the DRIVE or OVERDRIVE position. Hang a three-pound weight on the gearshift lever.
24. Raise the vehicle.
25. Remove the shift cable from the transmission lever bal...
(Posted in: Diagrams)

LCMflasherbypass.JPG
6968 hits | 88.02 KB | Posted: 11/27/08
Bypassing the LCM's flasher to use a standard stand alone auto flasher to cure fast flash condition when using LED bulbs
(Posted in: Panther LCM / lighting circuits and pinouts)

95-04cvgmqmmLCMPINOUTS.JPG
6961 hits | 70.15 KB | Posted: 1/1/09
1995-2004 CV/GMQ/MM
LCM pinouts

Most applicable to Town Cars
(Posted in: Panther LCM / lighting circuits and pinouts)

CarbonCanister.jpg
6930 hits | 58.4 KB | Posted: 1/11/05
Carbon Canister

The Fuel Tank Vapor System -

Gasoline is extremely volatile in almost all environments, and even diesel is aromatic. Since these vapors can be flammable or noxious, they must be contained & routed to the engine to be burned. B...
(Posted in: Diagrams)

IgLockCyl99.JPG
6910 hits | 67.39 KB | Posted: 11/30/06
None of the keys I got with the car worked very well in the ignition, so I bought a new lock cylinder at the dealership & had a key cut by the numbers to match the doors. I assembled & installed the cylinder per the included instructions & it works ...
(Posted in: 99 P71)