FordExcursions.com Forums

Ford Excursion Forums > Ford Excursion V8, V10, and Powerstroke > Excursion Discussion
European tail-light harness.
Thread Statistics:     Users to Post: 12   |   Total Posts: 27   |   Total Views: 3398
You must be logged in to post in or subscribe to this thread.Pages: 1 2 3
birdman127
• baltimore, MD, USA
• Registered on 10/13/2002
• 581 posts
1 Vehicle
Posted:5/18/2005 05:53
Bill,
How is the details on these lights. I have wanted them since the begining but didn't want the headaches trying to find the correct wires.
Thanks


Moderator
Scott

2000 ltd 6.8 V10*4.30LS*

Lots of mods
check my gallery


E. Long  Club OwnerSuperMotors Owner
Subscriber
Subscriber since 1/1/2001
• Atlanta, GA, USA
• Registered on 1/23/2001
• 2,228 posts
1 Vehicle
Posted:5/20/2005 00:19
I'll be putting together an install article on Bill's behalf in the next week (or so). I'm also interested in the mod, but I have yet to wrap my head around Bill's photos in the registry. Will be deciphering and breaking it down into steps.

-Eric

'67 Galaxie 500 - 390 FE, .030" over, FE to AOD adapter, disc brake conversion. The Daily Driver.
'00 Excursion - 7.3L PSD, LANDYOT Gen-II Radius Rods, Factory Tech Valve Body, 200K+ miles and going
smassie88
• Cumberland County, NJ, USA
• Registered on 9/6/2004
• 42 posts
Posted:5/20/2005 21:40
Any luck on the P/N for those front fender mounted turn signals? I've had no luck yet, Thanks.
CHPMustang
• Plano, TX, USA
• Registered on 7/24/2002
• 1,800 posts
1 Vehicle
Posted:5/21/2005 00:39
I have not had a chance to get a hold of the part numbers for the Aussie side turn signal lamps.I'm currently stuck on extended business in California probably for the next month or so and have no access to my normal resources

Bill
2002 Excursion XLT-P 4x4 7.3L Powerstroke Diesel




Chris Turrisi
• Long Island, NY, USA
• Registered on 8/5/2003
• 7 posts
1 Vehicle
Posted:3/27/2006 11:27
Bill,

I made a word file out of your pictures and directions, for easy printing and viewing. They are very detailed and were a great help. I did run into one small problem. (see below) I can send you the file (130mb) or post it on my web site (with your permission). I got my yellow tail lamps from ebay for $45 each new with gaskets.

I attempted this swap this weekend and ran into one little problem. How to get the green pin "out-of" of the gray connector at the steering column? I gave up after an hour of trying.

Thanks for the help,

Chris
CHPMustang
• Plano, TX, USA
• Registered on 7/24/2002
• 1,800 posts
1 Vehicle
Posted:3/27/2006 13:14
Howdy Chris!

Yeah getting the release clip out of the connector is sort of a bear for the first timer but it's okay to just clip the green wire and tape off the bare end then you should be good to go

I've also sent you an email

Bill
2002 Excursion XLT-P 4x4 7.3L Powerstroke Diesel




gunbare
• friendsville, TN, USA
• Registered on 12/12/2004
• 1 post
Posted:4/28/2006 20:37
Hey guys, where is the info on wiring the three color tails up?
Ford Excursion Forums > Ford Excursion V8, V10, and Powerstroke > Excursion Discussion
European tail-light harness.
Thread Statistics:     Users to Post: 12   |   Total Posts: 27   |   Total Views: 3398
You must be logged in to post in or subscribe to this thread.Pages: 1 2 3

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog