Rack1.JPG 934 hits | 84.22 KB | Posted: 12/2/03 Removing original rails and inserting mounting tabs. (Posted in: Cargo Rack)
Rack2.JPG 979 hits | 77.7 KB | Posted: 12/2/03 Mounting tabs for brackets slide into rails and screw for wedge fit to hold in place. (Posted in: Cargo Rack)
Rack3.JPG 897 hits | 66.47 KB | Posted: 12/2/03 Brackets that connect rail tabs to bed rails on rack. (Posted in: Cargo Rack)
Rack4.JPG 1006 hits | 128.92 KB | Posted: 12/2/03 One piece welded rack before putting in bedrail kit. (Posted in: Cargo Rack)
Rack5.JPG 1001 hits | 106.19 KB | Posted: 12/2/03 Getting help from my personal assistant! Ha! (Posted in: Cargo Rack)
Rack6.JPG 1069 hits | 77.57 KB | Posted: 12/2/03 Rack completed with new grill too! (Posted in: Cargo Rack)
WarnBumper1.JPG 1450 hits | 71.12 KB | Posted: 12/2/03 Relocating power steering cooler to make room for winch. (Posted in: Winch Bumper)
WarnBumper2.JPG 1640 hits | 69.69 KB | Posted: 12/2/03 Winch cradle mounts in tow hook holes. Bumper hangs on winch mount. (Posted in: Winch Bumper)
WarnBumper3.JPG 1453 hits | 73.56 KB | Posted: 12/2/03 I had to tilt winch tray forward to put in M15000 winch. After mounting my HS9500, I realized the control holes in the bumper were on the opposite side of this winch. Bumper is designed for M12000 and M15000 only. (Posted in: Winch Bumper)
WarnBumper5.JPG 1390 hits | 69.85 KB | Posted: 12/2/03 Must connect controller ground to motor ground terminal. As you can see everything is very tight with this monster winch! (Posted in: Winch Bumper)
WarnBumper6.JPG 2489 hits | 88.16 KB | Posted: 12/2/03 Winch tray is completely assembled with winch completed and operational. I had to undo the tow hooks to put the bumper on because they must zigzag past the bumper bracket and then come out of the hole in the front of the bumper. It is also easier t... (Posted in: Winch Bumper)
WarnBumper7.JPG 3679 hits | 83.88 KB | Posted: 12/2/03 Bumper side view, notice blocker beam behind and below bumper. I think I am going to take it off. (Posted in: Winch Bumper)
WarnBumper8.JPG 1711 hits | 90.78 KB | Posted: 12/2/03 Bumper mounted in final location, I just needed to add fog lights that I wired into factory harness up front. (Posted in: Winch Bumper)
XClearingRoad1.JPG 1428 hits | 108.45 KB | Posted: 12/2/03 Using new bumper as a bump stop while clearing a road in Julian, CA after the fires. (Posted in: Winch Bumper)