AC coolant lines.jpg 1498 hits | 65.31 KB | Posted: 6/10/05 There's about 4 mounting clamps holding up the 4 lines to the bottom of the truck body which will have to be dropped in order to remove the wire loom covering and insulation. (Posted in: AC Modification)
P1010154.JPG 1500 hits | 69.58 KB | Posted: 8/19/04 4 inch rear block from 03 super duty
03 rear Bilstein shocks
the back attachments from Landyots
Radius rods (Posted in: new lift)
XClearingRoad1.JPG 1501 hits | 108.45 KB | Posted: 12/2/03 Using new bumper as a bump stop while clearing a road in Julian, CA after the fires. (Posted in: Winch Bumper)
PIC00011.jpg 1501 hits | 52.24 KB | Posted: 12/5/04 My excursion didn't came with the reverse sensors and after back and forth with the dealer it will be to expensive, ECM issue, and a number to a local aftermarket version. (I belive all I need is the switch, the panel and the bumper with the sensors)... (Posted in: My 2000 Ford Excursion Limited)
4_seasons0002.jpg 1523 hits | 48.97 KB | Posted: 6/29/03 Just another view. The trailer is 7K Lbs. and pulling it was not a problem, even in the hills of NJ and PA. (Posted in: Hauling the trailer)
11june18200.JPG 1526 hits | 40.41 KB | Posted: 6/29/03 billet one piece grill and clear lenses (Posted in: Upgraded front end)
P1000029.JPG 1526 hits | 26.2 KB | Posted: 6/30/03 Some of you were asking what the tire was like...here's the tread pattern. 37x12.50.16.5LT (Posted in: Parts for lift)
00 X danielles interior1.JPG 1530 hits | 30.49 KB | Posted: 10/26/04 Here is picture taken of the front seat are. The heated seats are very nice come winter time in MN! (Posted in: My Pictures)
WarnBumper3.JPG 1531 hits | 73.56 KB | Posted: 12/2/03 I had to tilt winch tray forward to put in M15000 winch. After mounting my HS9500, I realized the control holes in the bumper were on the opposite side of this winch. Bumper is designed for M12000 and M15000 only. (Posted in: Winch Bumper)
