XClearingRoad1.JPG 1501 hits | 108.45 KB | Posted: 12/2/03 Using new bumper as a bump stop while clearing a road in Julian, CA after the fires. (Posted in: Winch Bumper)
PIC00011.jpg 1501 hits | 52.24 KB | Posted: 12/5/04 My excursion didn't came with the reverse sensors and after back and forth with the dealer it will be to expensive, ECM issue, and a number to a local aftermarket version. (I belive all I need is the switch, the panel and the bumper with the sensors)... (Posted in: My 2000 Ford Excursion Limited)
P1010154.JPG 1500 hits | 69.58 KB | Posted: 8/19/04 4 inch rear block from 03 super duty
03 rear Bilstein shocks
the back attachments from Landyots
Radius rods (Posted in: new lift)
AC coolant lines.jpg 1498 hits | 65.31 KB | Posted: 6/10/05 There's about 4 mounting clamps holding up the 4 lines to the bottom of the truck body which will have to be dropped in order to remove the wire loom covering and insulation. (Posted in: AC Modification)
BBeastRr3-4.JPG 1482 hits | 50.72 KB | Posted: 6/29/03 Rear 3/4 With Dog Sticker (Posted in: Stock Pics)
WarnBumper5.JPG 1482 hits | 69.85 KB | Posted: 12/2/03 Must connect controller ground to motor ground terminal. As you can see everything is very tight with this monster winch! (Posted in: Winch Bumper)
Bottom of Bag with Studs for Keeper Bar.JPG 1475 hits | 73.51 KB | Posted: 3/22/05 The studs were added so that a keeper bar could be used in place of the tab on the AIRLIFT lower bracket that was remove to provide room for the lower air line. (Posted in: Air Bags and Tank)
P1010212.JPG 1475 hits | 60.95 KB | Posted: 8/10/05 DR dual steering stabilizer with DR shocks (Posted in: my mods)
158013486aKuOiA_ph.jpg 1466 hits | 59.39 KB | Posted: 6/30/05 Some people have criticized me for insulating the compressor but I found that the compressor at least on the Powerstroke Diesel is cold when charging so I insulated it. I believe it has helped some and if it can drop the overall temps a degree or two... (Posted in: AC Modification)
