|
|
Stock fume collector
Photo courtesy of TXToy
|
|
|
 CCV Collector 2.jpg | Hits: 5301 | Size: 20.29 KB | Posted on: 2/21/05 | Link to this image
|
|
|
Photo of the fume shroud cut off inside the collector
|
|
|
You can see the 90 degree CCV elbow connected to a 3/4" ID plastic coupler with two screw clamps going to the 3/4" ID coolant hose
|
|
|
A shot of the coolant hose with the screw clamp heading down along the fender
|
|
|
A shot of the 3/4" coolant hose ending just a couple inches past the tranny crossmember/support
|
|
|
Just a shot of the coolant hose going down along the fender from the CCV cover
|
|
|
Just a peek at the compressor wheel with the fume collector removed
|
|
|
 Exhaust sleeve.jpg | Hits: 6309 | Size: 40.88 KB | Posted on: 2/21/05 | Link to this image
4" piece of aluminized exhaust pipe used for deleting the stock fume collector(Photo courtesy of TXToy)
|
|
|
4" piece of PVC pipe in place of the stock fume collector unit(Photo author unknown)
|
|
|
The stock fume collector location
|
|
|
 175161543sDmewU_ph.jpg | Hits: 6759 | Size: 47.47 KB | Posted on: 3/16/05 | Link to this image
A fine example of an intercooler removed before CCV mod,yuck!!!
Imagine what that oil coating does for air cooling efficiency,nothing at all.
(Photo author unknown)
|
|
|
Intercooler cleaned up and ready to be re-installed
|
|
|
Right side charge tube cleaned up and ready to be re-installed
|
CCV Modifications
