antiwrap axle template.JPG 2642 hits | 59.69 KB | Posted: 2/7/05 I used two peices of 1/4" plate steel about 6" x 8" and made template to "fit" what I had. When I d...
grinding the axle.JPG 1366 hits | 80.81 KB | Posted: 2/7/05 Too bad there were no pictures taken when I set my sock and foot on fire while welding the bracket o...
view of top antiwrap with dom in square tube.JPG 1524 hits | 94.81 KB | Posted: 2/7/05 The top and bottom bars are 1.5" x .25" DOM tubing. The top bar is about 36" long, the bottom bar i...
pic of shackle mount 37 inches by 2x3 inch 11 .jpg 1877 hits | 56.55 KB | Posted: 4/28/05 Picture of shackle mount while I was painting it. It is 37" long, 2"x 3" 11 gauge rectangle tube. ...
closeup of shackle mount 2 inch square tube.jpg 1820 hits | 40.1 KB | Posted: 4/28/05 Closeup detail of where the square tubing for the actuall shackle mounts. It was 7" from the left e...
another view of shackle.jpg 1409 hits | 45.12 KB | Posted: 4/28/05 Just another view of the shackle assembly, note the 1/4" spacers to allow more right/left movement w...
front view of axle plates installed.JPG 1419 hits | 45.48 KB | Posted: 4/29/05 Cruddy picture of the axle plates welded onto the Sterling. Look at those welds, can you say buble...
second view of axle plates installed.JPG 1478 hits | 47.69 KB | Posted: 4/29/05 Second picture of axle plates installed on Sterling. Not much better of a picture.
from rear of axle.JPG 1862 hits | 89.07 KB | Posted: 5/6/05 View of setup from rear of axle.
SRE and Bung shackle.JPG 1867 hits | 69.26 KB | Posted: 5/6/05 Heim (SRE) and bung shackle picture 1/4.
wrap bar template.jpg 2520 hits | 42.83 KB | Posted: 6/6/05 This is the template for the steel that welds onto the rear axle. The two peices are 1/4" steel tha...
Anti Wrap Bar, winter 05
