Member Gallery Search Results
 Showing 451 - 495 of 539 files.Pages: 1 ... 8 9 10 11 12 
IDThumbnailCaptionModelCommentsHitsUpdated
VoltReg3.pg.jpg
654 hits | 52.36 KB | Posted: 3/8/06

Voltage regulator. (The 2 screws in the picture hold the brush assembly to the regulator. T20 Torx bit)
(Posted in: Voltage Regulator Swap)
VoltReg1.jpg
661 hits | 46.47 KB | Posted: 3/8/06

Side view....showing brush assembly
(Posted in: Voltage Regulator Swap)
Brushes.jpg
671 hits | 65.01 KB | Posted: 3/8/06

This is the brush assembly bolted in place on the back of the voltage regulator
(Posted in: Voltage Regulator Swap)
BrushesRemoved.jpg
657 hits | 54.12 KB | Posted: 3/8/06

When you remove the 2 screws....the brush assembly simply comes off of the regulator
(Posted in: Voltage Regulator Swap)
BrushesRemovedTop.jpg
681 hits | 45.93 KB | Posted: 3/8/06

Another shot of the brushes removed
(Posted in: Voltage Regulator Swap)
BrushesScrewsLoose.jpg
706 hits | 65.5 KB | Posted: 3/8/06

Brush assembly screws loosened
(Posted in: Voltage Regulator Swap)
BrushRetainer.jpg
667 hits | 55.8 KB | Posted: 3/8/06

When you go to reinstall the regulator the brushes have to be held back into the housing. Use a paper clip to hold them in place.
(Posted in: Voltage Regulator Swap)
Brushes1.jpg
646 hits | 54.66 KB | Posted: 3/8/06

With the retaining screws tight, press the brushes into the housing.
(Posted in: Voltage Regulator Swap)
BrushesLocked.jpg
654 hits | 60.38 KB | Posted: 3/8/06

Here you can see that the brushes are held in place with the paper clip
(Posted in: Voltage Regulator Swap)
BrushesLocked1.jpg
740 hits | 58.68 KB | Posted: 3/8/06

Another view of the brushes held in place
(Posted in: Voltage Regulator Swap)
InstallingReg.jpg
669 hits | 76.66 KB | Posted: 3/8/06

To install, simply lay the regulator into place.
(Posted in: Voltage Regulator Swap)
InstallingReg1.jpg
607 hits | 82.94 KB | Posted: 3/8/06

Ready to bolt in
(Posted in: Voltage Regulator Swap)
InstallingReg2.jpg
650 hits | 77.12 KB | Posted: 3/8/06

Tighten the mounting bolts
(Posted in: Voltage Regulator Swap)
RemovingLock.jpg
648 hits | 64.24 KB | Posted: 3/8/06

When the regulator is in place and screws tightened, pull the paper clip out.
(Posted in: Voltage Regulator Swap)
RemovingLock1.jpg
671 hits | 66.17 KB | Posted: 3/8/06

You will hear the brushes pop out of the housing.....and your done!
(Posted in: Voltage Regulator Swap)
DCP_8087.jpg
747 hits | 88.47 KB | Posted: 4/3/06

Drivers side header
(Posted in: 460 CV Project)
DCP_8089.jpg
725 hits | 76.08 KB | Posted: 4/3/06

Passenger side header
(Posted in: 460 CV Project)
DCP_8091.jpg
762 hits | 82.87 KB | Posted: 4/3/06

Steering shaft
(Posted in: 460 CV Project)
P1000054.jpg
648 hits | 121.62 KB | Posted: 7/31/06

Can you believe it was left in a parking lot?
(Posted in: 1992 Mustang LX)
P1000056.jpg
673 hits | 111.13 KB | Posted: 7/31/06

Someone started body work. Plenty of work still too do
(Posted in: 1992 Mustang LX)
P1000058.jpg
658 hits | 102.82 KB | Posted: 7/31/06

A little weathered.
(Posted in: 1992 Mustang LX)
P1000060.jpg
709 hits | 91.61 KB | Posted: 7/31/06

Needs a good cleaning, but not bad for an abandoned car
(Posted in: 1992 Mustang LX)
P1000071.jpg
676 hits | 101.04 KB | Posted: 7/31/06

Bone stock 5.0. Completely un-molested....even the air silencer is in the fender!
(Posted in: 1992 Mustang LX)
P1010034.JPG
716 hits | 110.11 KB | Posted: 9/18/06

Stock upper control arms ('98-'02)
(Posted in: Other pics)
P1010039.JPG
640 hits | 104.65 KB | Posted: 9/18/06

Control arm (top view)
(Posted in: Other pics)
P1010044.JPG
649 hits | 74.46 KB | Posted: 9/18/06

Side view
(Posted in: Other pics)
P1010045.JPG
670 hits | 73.94 KB | Posted: 9/18/06

Side view
(Posted in: Other pics)
Dash.jpg
769 hits | 77.36 KB | Posted: 9/19/06

Digital guages everywhere!
(Posted in: 460 CV Project)
Engine.jpg
797 hits | 118.35 KB | Posted: 9/19/06

Newly powder-coated accesories and brackets
(Posted in: 460 CV Project)
DrHader.jpg
699 hits | 99.84 KB | Posted: 9/19/06

Driver's side header....plenty of room for the steering shaft with these!
(Posted in: 460 CV Project)
PassHeader.jpg
941 hits | 92.58 KB | Posted: 9/19/06

Passenger side header.....so pretty!
(Posted in: 460 CV Project)
TBfront.jpg
634 hits | 108.5 KB | Posted: 11/21/06

'87-'93 Mustang TB
(Posted in: Parts)
TBrear.jpg
655 hits | 114.08 KB | Posted: 11/21/06

Rear view
(Posted in: Parts)
UpperIntakeTop.jpg
643 hits | 95.4 KB | Posted: 11/21/06

Mustang HO upper intake
(Posted in: Parts)
UpperIntakeTBOpening.jpg
601 hits | 58.63 KB | Posted: 11/21/06

(Posted in: Parts)
UpperIntakeBottom.jpg
726 hits | 105.3 KB | Posted: 11/21/06

(Posted in: Parts)
Head1.jpg
673 hits | 79.05 KB | Posted: 11/21/06

E7TE heads
(Posted in: Parts)
Head2.jpg
670 hits | 76.59 KB | Posted: 11/21/06

(Posted in: Parts)
Head3.jpg
624 hits | 64.18 KB | Posted: 11/21/06

(Posted in: Parts)
Head4.jpg
714 hits | 60.39 KB | Posted: 11/21/06

(Posted in: Parts)
Head5.jpg
674 hits | 51.67 KB | Posted: 11/21/06

(Posted in: Parts)
Head6.jpg
677 hits | 49.82 KB | Posted: 11/21/06

(Posted in: Parts)
Head7.jpg
720 hits | 68.99 KB | Posted: 11/21/06

(Posted in: Parts)
Head8.jpg
816 hits | 64.21 KB | Posted: 11/21/06

(Posted in: Parts)
P1010331.jpg
770 hits | 85.32 KB | Posted: 3/16/07

(Posted in: Parts)
 Showing 451 - 495 of 539 files.Pages: 1 ... 8 9 10 11 12 
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2026 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog