DCP_4940.JPG
897 hits | 98.4 KB | Posted: 8/20/03
Looks nice in there
(Posted in: New Engine Project)

DCP_4941.JPG
983 hits | 94.7 KB | Posted: 8/20/03
Hmm...leave the hood off?
(Posted in: New Engine Project)

DCP_4942.JPG
860 hits | 84.42 KB | Posted: 8/20/03
Hood's back on
(Posted in: New Engine Project)

DCP_4943.JPG
996 hits | 96.95 KB | Posted: 8/20/03
Need to clean up under there
(Posted in: New Engine Project)

DCP_4944.JPG
978 hits | 98.38 KB | Posted: 8/20/03
Have to clean the K&N too
(Posted in: New Engine Project)

DCP_5818.jpg
995 hits | 81.05 KB | Posted: 4/10/04
Modified throttle & cruise cables
(Posted in: New Engine Project)

DCP_5819.jpg
914 hits | 81.1 KB | Posted: 4/10/04
Throttle & Cruise cables
(Posted in: New Engine Project)

DCP_5820.jpg
771 hits | 80.18 KB | Posted: 4/10/04
Throttle & Cruise cables
(Posted in: New Engine Project)

DCP_5822.jpg
713 hits | 66.14 KB | Posted: 4/10/04
Throttle cable mount. Using the original alternator bracket and a cut piece of angle steel
(Posted in: New Engine Project)

DCP_5823.jpg
807 hits | 68.9 KB | Posted: 4/10/04
Close up of cable mounts. Cruise cable is cut from the throttle cable and drilled to mount to new intake
(Posted in: New Engine Project)

DCP_5824.jpg
834 hits | 72.28 KB | Posted: 4/10/04
Another view of the throttle cable
(Posted in: New Engine Project)

DCP_5825.jpg
827 hits | 72.32 KB | Posted: 4/10/04
Throttle cable top view
(Posted in: New Engine Project)

DCP_5826.jpg
843 hits | 60.84 KB | Posted: 4/10/04
Orignal '00 cruise mount ground down to accept '93 throttle cable connector
(Posted in: New Engine Project)

DCP_5828.jpg
767 hits | 57.19 KB | Posted: 4/10/04
Another view of ground down mount
(Posted in: New Engine Project)

93DPFE.jpg
1102 hits | 35.3 KB | Posted: 4/21/04
This is a lousy pic of my DPFE sensor mounted on the rear of my '00 intake
(Posted in: New Engine Project)

PassengerSide.jpg
849 hits | 87.01 KB | Posted: 4/21/04
Passenger side picture of the engine
(Posted in: New Engine Project)

EGRSolenoid.jpg
1142 hits | 74.43 KB | Posted: 4/21/04
'93 EGR solenoid mounted in the stock '00 location
(Posted in: New Engine Project)

EGRSupplyTube.jpg
873 hits | 60.23 KB | Posted: 4/21/04
The red lines are the EGR supply tube on an '01 Grand Marquis engine
(Posted in: New Engine Project)

EGRSupplyTube2.jpg
1086 hits | 81.26 KB | Posted: 4/21/04
The red lines are the EGR supply tube. The black part with the grey plug is the '01 DPFE sensor
(Posted in: New Engine Project)

EGRSupplyTube5.jpg
981 hits | 121.67 KB | Posted: 4/21/04
Better shot of the EGR supply from passenger side exhaust manifold up.
(Posted in: New Engine Project)

EGRSupplyTube6.jpg
1027 hits | 107.73 KB | Posted: 4/21/04
Another angle on the supply tube.
(Posted in: New Engine Project)

DCP_4930.jpg
840 hits | 88.24 KB | Posted: 9/5/04
Passenger side engine mount pad
The red arrows point where the bolt heads are located.
(Posted in: New Engine Project)

DCP_4931.jpg
931 hits | 91.02 KB | Posted: 9/5/04
Drivers side engine mount pad
The arrows point to where the bolt heads are located.
(Posted in: New Engine Project)

PrintedCircuitBoard.jpg
901 hits | 89.71 KB | Posted: 1/9/05
Finally opened up the '00 transmission to install the older TCC Solenoid. This is the printed circuit board Ford started using in '98-up 4R70W's
(Posted in: New Engine Project)

StockParts.jpg
858 hits | 58.79 KB | Posted: 1/9/05
Here are the two solenoids side by side.
(Posted in: New Engine Project)

DCP_6424.jpg
901 hits | 79.28 KB | Posted: 1/9/05
The parts are identical in size and shape except for the electrical connector.
(Posted in: New Engine Project)

DCP_6425.jpg
829 hits | 37.55 KB | Posted: 1/9/05
Blurry...but just for reference
(Posted in: New Engine Project)

DCP_6428.jpg
916 hits | 40.51 KB | Posted: 1/9/05
Cutting down the shroud around the connectors showed that the contacts are the same size as well.
(Posted in: New Engine Project)

DCP_6427.jpg
905 hits | 38.55 KB | Posted: 1/9/05
The arrow points to a "bump" on the side of the '93 solenoid. I found out, after installing it back in the transmission, that this won't let the CB plug in completely.
(Posted in: New Engine Project)

DCP_6426.jpg
723 hits | 40.53 KB | Posted: 1/9/05
Better picture of the "bump". I didn't feel like trying to make the bump look like the lock tab, so I just ground it off.
(Posted in: New Engine Project)

DynoGraphColor.jpg
852 hits | 71.48 KB | Posted: 5/17/05
Dyno Graph
(Posted in: New Engine Project)

Pulll3.jpg
805 hits | 41.45 KB | Posted: 5/17/05
My way....
(Posted in: New Engine Project)

Pull5.jpg
737 hits | 40.43 KB | Posted: 5/17/05
Chipped
(Posted in: New Engine Project)

XPipe.JPG
3471 hits | 42.92 KB | Posted: 6/30/03
X-pipe close-up
(Posted in: Exhaust)

Mufflers.JPG
1423 hits | 38.02 KB | Posted: 6/30/03
Mufflers
(Posted in: Exhaust)

ExhaustView.JPG
1460 hits | 54.06 KB | Posted: 6/30/03
Exhaust
(Posted in: Exhaust)

Undercar.JPG
1391 hits | 39.46 KB | Posted: 6/30/03
Camaro exhaust tips
(Posted in: Exhaust)

DCP_4428.jpg
1223 hits | 41.87 KB | Posted: 6/30/03
Driver's side tail-pipe
(Posted in: Exhaust)

DCP_4429.jpg
1156 hits | 45.77 KB | Posted: 6/30/03
Close up of the heat shield...between the pipe and fuel filter mounted directly above.
(Posted in: Exhaust)

DCP_4430.jpg
1393 hits | 42.61 KB | Posted: 6/30/03
Looking straight back at the Driver's side pipe
(Posted in: Exhaust)

DCP_4431.jpg
1119 hits | 44.47 KB | Posted: 6/30/03
Driver's side, from the rear
(Posted in: Exhaust)

DCP_4432.jpg
1562 hits | 45.81 KB | Posted: 6/30/03
Passenger side pipe.
(Posted in: Exhaust)

DCP_4433.jpg
1305 hits | 41.96 KB | Posted: 6/30/03
Passenger side pipe
(Posted in: Exhaust)

DCP_4434.jpg
1132 hits | 45.78 KB | Posted: 6/30/03
Passenger side hanger...welded to pipe
(Posted in: Exhaust)

DCP_4435.jpg
1270 hits | 43.81 KB | Posted: 6/30/03
Passenger side muffler and tailpipe
(Posted in: Exhaust)