VoltageRegScrews.jpg 594 hits | 75.23 KB | Posted: 3/8/06 Remove the 4 screws that the blue arrows point too. (T20 torx bit)
SideView.jpg 577 hits | 69.06 KB | Posted: 3/8/06 Side shot of the voltage regulator
ScrewRemoved.jpg 609 hits | 79.45 KB | Posted: 3/8/06 When the screws are removed the voltage regulator will be pushed up by the brushes.
ScrewRemovedSide.jpg 605 hits | 60.07 KB | Posted: 3/8/06 Another shot with the screws removed. The regulator simply lifts out.
VoltReg3.pg.jpg 587 hits | 52.36 KB | Posted: 3/8/06 Voltage regulator. (The 2 screws in the picture hold the brush assembly to the regulator. T20 Torx b...
BrushesRemoved.jpg 583 hits | 54.12 KB | Posted: 3/8/06 When you remove the 2 screws....the brush assembly simply comes off of the regulator
BrushesRemovedTop.jpg 616 hits | 45.93 KB | Posted: 3/8/06 Another shot of the brushes removed
BrushRetainer.jpg 603 hits | 55.8 KB | Posted: 3/8/06 When you go to reinstall the regulator the brushes have to be held back into the housing. Use a pape...
Brushes1.jpg 576 hits | 54.66 KB | Posted: 3/8/06 With the retaining screws tight, press the brushes into the housing.
BrushesLocked.jpg 591 hits | 60.38 KB | Posted: 3/8/06 Here you can see that the brushes are held in place with the paper clip
BrushesLocked1.jpg 671 hits | 58.68 KB | Posted: 3/8/06 Another view of the brushes held in place
InstallingReg.jpg 602 hits | 76.66 KB | Posted: 3/8/06 To install, simply lay the regulator into place.
InstallingReg1.jpg 538 hits | 82.94 KB | Posted: 3/8/06 Ready to bolt in
Voltage Regulator Swap
