|
|
 VoltageRegScrews.jpg | Hits: 596 | Size: 75.23 KB | Posted on: 3/8/06 | Link to this image
Remove the 4 screws that the blue arrows point too. (T20 torx bit)
|
|
|
Side shot of the voltage regulator
|
|
|
When the screws are removed the voltage regulator will be pushed up by the brushes.
|
|
|
 ScrewRemovedSide.jpg | Hits: 608 | Size: 60.07 KB | Posted on: 3/8/06 | Link to this image
Another shot with the screws removed. The regulator simply lifts out.
|
|
|
Voltage regulator. (The 2 screws in the picture hold the brush assembly to the regulator. T20 Torx bit)
|
|
|
Side view....showing brush assembly
|
|
|
This is the brush assembly bolted in place on the back of the voltage regulator
|
|
|
 BrushesScrewsLoose.jpg | Hits: 641 | Size: 65.5 KB | Posted on: 3/8/06 | Link to this image
Brush assembly screws loosened
|
|
|
When you remove the 2 screws....the brush assembly simply comes off of the regulator
|
|
|
 BrushesRemovedTop.jpg | Hits: 618 | Size: 45.93 KB | Posted on: 3/8/06 | Link to this image
Another shot of the brushes removed
|
|
|
When you go to reinstall the regulator the brushes have to be held back into the housing. Use a paper clip to hold them in place.
|
|
|
With the retaining screws tight, press the brushes into the housing.
|
|
|
Here you can see that the brushes are held in place with the paper clip
|
|
|
Another view of the brushes held in place
|
|
|
To install, simply lay the regulator into place.
|
|
|
Tighten the mounting bolts
|
|
|
When the regulator is in place and screws tightened, pull the paper clip out.
|
|
|
You will hear the brushes pop out of the housing.....and your done!
|
Voltage Regulator Swap
