Raymond Jones > 1993 Mercury Grand Marquis > open folder Voltage Regulator Swap

Remove the 4 screws that the blue arrows point too. (T20 torx bit)
Url
Tag
Img
Thumb
Side shot of the voltage regulator
Url
Tag
Img
Thumb
When the screws are removed the voltage regulator will be pushed up by the brushes.
Url
Tag
Img
Thumb
Another shot with the screws removed. The regulator simply lifts out.
Url
Tag
Img
Thumb
Voltage regulator. (The 2 screws in the picture hold the brush assembly to the regulator. T20 Torx b...
Url
Tag
Img
Thumb
Side view....showing brush assembly
Url
Tag
Img
Thumb
This is the brush assembly bolted in place on the back of the voltage regulator
Url
Tag
Img
Thumb
Brush assembly screws loosened
Url
Tag
Img
Thumb
When you remove the 2 screws....the brush assembly simply comes off of the regulator
Url
Tag
Img
Thumb
Another shot of the brushes removed
Url
Tag
Img
Thumb
When you go to reinstall the regulator the brushes have to be held back into the housing. Use a pape...
Url
Tag
Img
Thumb
With the retaining screws tight, press the brushes into the housing.
Url
Tag
Img
Thumb
Here you can see that the brushes are held in place with the paper clip
Url
Tag
Img
Thumb
Another view of the brushes held in place
Url
Tag
Img
Thumb
To install, simply lay the regulator into place.
Url
Tag
Img
Thumb
Ready to bolt in
Url
Tag
Img
Thumb
Tighten the mounting bolts
Url
Tag
Img
Thumb
When the regulator is in place and screws tightened, pull the paper clip out.
Url
Tag
Img
Thumb
You will hear the brushes pop out of the housing.....and your done!
Url
Tag
Img
Thumb
 
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog