DSC00045.JPG 187 hits | 110.56 KB | Posted: 7/27/16 Geometry is wrong on pull cable transport could not unlatch hitch with out lifting handle manually (Posted in: trailer)
DSC00047.JPG 177 hits | 102.42 KB | Posted: 7/27/16 Cable dose not pull handle all the way to vertical position to unlatch this is as far as the cable will pull it, Will have to try reroute the cable to pull the handle properly (Posted in: trailer)
DSC00048.JPG 170 hits | 85.33 KB | Posted: 7/27/16 needs to be here to unlatch (Posted in: trailer)
DSC00049.JPG 204 hits | 76.82 KB | Posted: 7/27/16 Straps do not fit or support tanks (Posted in: trailer)
DSC00050.JPG 215 hits | 55.09 KB | Posted: 7/27/16 this is not supporting the tank and the edges seem to be stressing corners of the tank (Posted in: trailer)
DSC00051.JPG 207 hits | 73.21 KB | Posted: 7/27/16 bracket dose not let the screws tighten down the angle of the bracket is causing it to cut/wear in to the tank (Posted in: trailer)
DSC00052.JPG 197 hits | 77.4 KB | Posted: 7/27/16 the straps on the front grey water tank fit better but I think they should have rubber under them to help prevent the straps from digging into the tank. (Posted in: trailer)
DSC00054.JPG 192 hits | 63.7 KB | Posted: 7/27/16 not sure why this is bent around so you cannot get to bolts (Posted in: trailer)
DSC00055.JPG 186 hits | 50.65 KB | Posted: 7/27/16 Living quarters door Is not mounted square to frame causing it to hang up on one of the door screws it is already already digging into sill plate. (Posted in: trailer)
DSC00058.JPG 260 hits | 86.97 KB | Posted: 7/27/16 Seal on generator door was not properly installed, when the door was put on it could not sit properly on the seal. I am assuming this caused the door not to be properly installed causing it to come off during transit. I will need to pull at least th... (Posted in: trailer)
DSC00064.JPG 245 hits | 34.69 KB | Posted: 7/27/16 One of nuts for the hinges on hay box is already backing off the bolt. They should be double nutted or Nyloc style and then bolts could be a couple of inches shorter because you would not need the extra length for keep the nut from falling off (Posted in: trailer)
P3030345.JPG 3812 hits | 77.15 KB | Posted: 2/24/04 This was just after the final polishing. A little free plug for Soundview Auto Body.
Paul does great things with old iron! (Posted in: 67 Ranchero)
P3240400.JPG 3588 hits | 67.49 KB | Posted: 2/24/04 A little different view / angle. (Posted in: 67 Ranchero)
P2210271.JPG 3868 hits | 96.38 KB | Posted: 2/24/04 The Heartbreak of Chevrolet... The Heart-Beat of America: FoMoCo old school style.
A 1970 numbers matching 351 Cleveland 4-V. Rated at 300bhp bone stock, this one should be a lot closer to 330. (Posted in: 67 Ranchero)
P2210270.JPG 3374 hits | 86.23 KB | Posted: 2/24/04 I'm one of those who just hate a dirty engine. LOL (Posted in: 67 Ranchero)
