Silicone adhesive was not put in the correct place to hit the cross member in several places as can be seen by the next few pictures

panel loose because of missing silicone

panel loose because of missing silicone

Geometry is wrong on pull cable transport could not unlatch hitch with out lifting handle manually

Cable dose not pull handle all the way to vertical position to unlatch this is as far as the cable will pull it, Will have to try reroute the cable to pull the handle properly

needs to be here to unlatch

Straps do not fit or support tanks

this is not supporting the tank and the edges seem to be stressing corners of the tank

bracket dose not let the screws tighten down the angle of the bracket is causing it to cut/wear in to the tank

the straps on the front grey water tank fit better but I think they should have rubber under them to help prevent the straps from digging into the tank.

not sure why this is bent around so you cannot get to bolts

Living quarters door Is not mounted square to frame causing it to hang up on one of the door screws it is already already digging into sill plate.

Seal on generator door was not properly installed, when the door was put on it could not sit properly on the seal. I am assuming this caused the door not to be properly installed causing it to come off during transit. I will need to pull at least the back of the cover of to put seal on.

One of nuts for the hinges on hay box is already backing off the bolt. They should be double nutted or Nyloc style and then bolts could be a couple of inches shorter because you would not need the extra length for keep the nut from falling off