Thread Statistics: Users to Post: 2 | Total Posts: 2 | Total Views: 385
You must be logged in to post in or subscribe to this thread.
Pages: 1
MossbergHood
• Gaithersburg, MD, USA
• Registered on 2/29/2016
• 1 post
Posted:2/29/2016 18:53
Help!! I'm about to go crazy here. My Vic is driving me nuts. I put the computer on it and keep getting code P0102. Replaced the mass air flow sensor, cleaned the throttle body, changed fuel filter....no help. I'm at my wits end here. Idles fine but when I give it any gas it gurgles and the wrench of death pops up on the dash.
The code does track back to the MAF so if you have replaced it check out your wiring. Check to make sure your connections are clean and free of debris. If they are you will most likely have to start tracing your wiring harness to see if there is any damage to the wiring.
Posted:2/29/2016 18:53