SuperMotors.net Forums

Forums > Car and Truck Make and Model Specific > Other Ford Trucks
Motor Towers or Supports Question
Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 1159
You must be logged in to post in or subscribe to this thread.Pages: 1
John Barrett
• West Palm Beach, FL, USA
• Registered on 1/31/2003
• 106 posts
• 1
Posted:10/23/2003 11:20
Got a 1979 F250, 4 wheel drive, came with a 300cid inline 6.
What was going to happen one way or another is to install a 302cid motor in it.

Does any one know if back in 1979, if they came with a 302cid motor or was all the F250 with big blocks only (351M/400, 460) ?.

Will installing 302cid motor towers out of a 2 wheel drive work or not.
edited 10/23/2003 11:55
Sean Rossi
• San Diego, CA, USA
• Registered on 10/24/2003
• 5 posts
• 1
Posted:10/24/2003 14:50
i am no expert... but most 2-wheel configs have different mounting locations than a 4x4... this is not FACT however, just an opinion.

I used to have a 4x4 chevy that someone had converted from a 2wd. i didnt see any custom weld or anything
Forums > Car and Truck Make and Model Specific > Other Ford Trucks
Motor Towers or Supports Question
Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 1159
You must be logged in to post in or subscribe to this thread.Pages: 1