SuperMotors.net Forums
Goofy1129
 |
|
• Fallon, NV, USA |
|
• Registered on 7/23/2012 |
|
• 2 posts |
|
|
|
 Posted:7/23/2012 16:41 |
|
|
hello I am trying to find out where i can get the complete front suspension for a 2006 to 2007 crown vic to put under my 1976 f-100 and help would be great.
P.S. i forgot to mention i need this out of police interecepter |
|
jdmeaux
 |
|
• Lafayette, LA, USA |
|
• Registered on 1/5/2009 |
|
• 525 posts |
• 1
|
|
|
Posted:7/23/2012 19:19 |
|
|
Your best bet would be to look at the local junk yards or yards not far away. You would need the entire front end with no engine or trans. Man, I hope you are good at welding and measuring. You will need to make ABSOLUTELY sure that everything is straight to do any welding and make sure its straight after the welding.
You also may want to try here: http://info.automotix.net/usedautoparts/
Good luck..
*******************
PROUD MEMBER of www.crownvic.net
It's just a SUPER-DUTY Mustang GT Sedan. 198K miles and still rolling HARD.
1997 Crown Victoria P71 SVT *** ex-US Marshall service (the CAR)
STOCK?? I bet it was modified. 
13.26 @ 107.24 MPH 1/4 mi w/ me, tools, & full tank of 93 octane
I added CAI, NICHE 19 X 8.5 " wheels with 245/45ZR 19 rubbers, and completely rebuilt the front end with poly bushings, Kooks headers, 2 1/4inch exhaust, TCI 2200-2400 rpm Stall converter
.PLANS:: engine upgrade, 5.4L 2v stroker, rebuild interior in leather w/ buckets, thinking about turbos
|
|
Goofy1129
|
|
• Fallon, NV, USA |
|
• Registered on 7/23/2012 |
|
• 2 posts |
|
|
|
|
Posted:7/23/2012 21:34 |
|
|
|
the reason that I want the front end out of a 2006 - 2007 is that they are bolt ins and the measurements are only off by 1/10 th of a inch as for the width of the frames between f100 and a crown vic. the front suspension out of crown vic police interecpter is as bout as heavy duty as you can get so i t should hold up to anyhting can do to it |
|
|
|
