busa1b.jpg 4566 hits | 88.55 KB | Posted: 9/12/06 By Arthur Jensen
[b]Blingin' Billet Bezel: We Install a PPM Custom's Chrome Billet 'Busa ...
busa2.jpg 2561 hits | 74.29 KB | Posted: 9/12/06 Start by removing the three Allen screws that hold the lower half of the inner fairing to the bike.
busa3.jpg 2504 hits | 73.56 KB | Posted: 9/12/06 Release the pins that hold the inner fairing to the windscreen supports by pushing in the center wit...
busa4.jpg 2640 hits | 85.43 KB | Posted: 9/12/06 From the top, carefully pull the inner fairing away from the bike. The lower edge fits into the fra...
busa5.jpg 2892 hits | 105.17 KB | Posted: 9/12/06 The stock 'Busa bezel is held on with two Phillips screws along the bottom edge and double sided tap...
busa6.jpg 3398 hits | 99.25 KB | Posted: 9/12/06 Since the bezel is still attached by the double-sided tape, you will have to pry it up carefully to ...
busa7.jpg 4126 hits | 83.13 KB | Posted: 9/12/06 Before mounting the PPM Custom billet bezel with the provided adhesive, set the new part in place to...
busa8.jpg 2677 hits | 90.58 KB | Posted: 9/12/06 To permanently mount the bezel, peel the cover-strips off the double-sided tape on the back of the P...
busa9a.jpg 2784 hits | 80.96 KB | Posted: 9/12/06 Once the screws are tight, install the new foam weather seal around the bottom and sides of the beze...
busa10a.jpg 2843 hits | 101.14 KB | Posted: 9/12/06 Next, install the inner fairing. Starting from the rear of the fairing pieces, work your way forward...
busa11.jpg 3544 hits | 69.62 KB | Posted: 9/12/06 To install the pins that hold the inner fairing to the windscreen supports you must first reset them...
busa12.jpg 2641 hits | 78.3 KB | Posted: 9/12/06 Now that the fairings are in place, tighten all three Allen screws.
busa13.jpg 3322 hits | 118.49 KB | Posted: 9/12/06 Seen side-by-side, the stock and PPM bezel are quite a contrast. While the stock part’s faux-carb...
PPM Custom's Chrome Billet Hayabusa Gauge Bezel
