TachBefore.JPG
2461 hits | 39.41 KB | Posted: 5/21/05
This is where I plan to mount the tachometer, but I haven't decided if I'll cut out the entire clock...

Tach&Driver.JPG
2260 hits | 54.36 KB | Posted: 5/21/05
I ordered this Cyberdyne 2" Digital Tach with memory & FRPP Tach Driver from Summit for ~$140. I wo...

TachDriver.JPG
2689 hits | 60.51 KB | Posted: 5/21/05
FRPP M-17361-A200 is $70 from Summit, and includes Scotch-type tap connectors, but I won't be using ...

TachDriverIn.JPG
2858 hits | 58.25 KB | Posted: 5/21/05
The tach driver is semi-permanently integrated into the EEC harness. The green wire will go thru pin...

Clock1.JPG
2094 hits | 77.67 KB | Posted: 5/21/05
While removing the dash finisher, I noticed a possible new location for the clock, so I did some rou...

Clock3.JPG
1957 hits | 74.63 KB | Posted: 5/21/05
It fit well, even without fasteners, so I decided to put it here permanently. The wires reach witho...

Clock4.JPG
1948 hits | 70.62 KB | Posted: 5/21/05
The reflection of the camera in the clock lens is a distraction, and the photo makes the edges of th...

TachConn.JPG
2025 hits | 83.68 KB | Posted: 5/21/05
The only 4-wire connector I had handy was for a trailer, but it works. The memory (blue) is shorted...

TachPlate.JPG
2147 hits | 36.63 KB | Posted: 5/21/05
I used a scrap of 16ga. steel plate to make a mounting panel. A palm sander smoothed it out in no t...

TachPainted.JPG
2348 hits | 81.09 KB | Posted: 5/21/05
I just used some cheap flat black spray paint, but I might redo it someday. The sides of the plate ...

TachFinished.JPG
2716 hits | 46.9 KB | Posted: 5/21/05
I probably could have done a little better, but I don't like the look of the display. I've pulled i...