Spotlight connector.JPG 1778 hits | 50.91 KB | Posted: 3/1/06 The P71 spotlight connector and wiring in the a-pillar. (Posted in: A-pillar gauges)
Wiring on Dash.JPG 1615 hits | 54.1 KB | Posted: 3/1/06 The wiring that will be snaked through the side of the dash. Note the coathanger coming up through the dash. (Posted in: A-pillar gauges)
Wireloom Dash.JPG 1541 hits | 33.58 KB | Posted: 3/1/06 All wiring was run through this wireloom for a cleaner install and to keep the wiring together. (Posted in: A-pillar gauges)
Tach wire through firewall.JPG 2379 hits | 33.25 KB | Posted: 3/1/06 The green wire is the tach wire, running through a grommet into the firewall.
It's blurry but you get the idea. (Posted in: A-pillar gauges)
Tach wire engine bay.JPG 2170 hits | 35.23 KB | Posted: 3/1/06 The tach wire coming through the grommet into the engine bay. (Posted in: A-pillar gauges)
Holes for tach adapter.JPG 2230 hits | 51.43 KB | Posted: 3/1/06 The holes drilled for the tach adapter. The pick used to pierce the grommet can be seen on the fusebox. (Posted in: A-pillar gauges)
Power diode spliced.JPG 5483 hits | 64.83 KB | Posted: 3/1/06 The R/LG wire was cut can connected to the tach adapter. I accidentally spliced into the wrong R/LG wire. Hence the extra white posi connector. (Posted in: A-pillar gauges)
Wiring up.JPG 2154 hits | 62.43 KB | Posted: 3/1/06 I used wiring looms and electrical tape to clean up the wiring install and to give a factory appearance. (Posted in: A-pillar gauges)
A-pillar tape.JPG 1977 hits | 26.07 KB | Posted: 3/3/06 I attempted to use double-sided moulding tape to install the pod to the A-pillar. However, this did not hole and I ended up using the 3/16" fasteners supplied with the pod. (Posted in: A-pillar gauges)
Tach adapter installation complete.JPG 2043 hits | 56.33 KB | Posted: 3/3/06 Complete. The adapter blends in well with the engine bay and the wire looms and electrical tape conceal the additional wiring. (Posted in: A-pillar gauges)
Mounted.JPG 2675 hits | 56.31 KB | Posted: 3/3/06 The pod and pillar mounted, awaiting the gauges. (Posted in: A-pillar gauges)
