DSCN2152.jpg
712 hits | 55.03 KB | Posted: 5/18/05
97 10.25 Sterling rear axle, out of an f350. Has since been rebuilt with Yukon 4.88 gears (long pini...

DSCN2210.jpg
693 hits | 43.22 KB | Posted: 6/6/05
axle in

DSCN2211.jpg
730 hits | 45.57 KB | Posted: 6/6/05

DSCN2212.jpg
860 hits | 30.4 KB | Posted: 6/6/05
Not the greatest shackle angle..may correct that soon

This is with a 2" belltech lowering shackle

DSCN2220.jpg
713 hits | 49.99 KB | Posted: 6/7/05
bracket-be gone

Had to clearence the body a bit with a torch to get access at the top bolts, and ...

DSCN2221.jpg
651 hits | 39.82 KB | Posted: 6/7/05

DSCN2222.jpg
686 hits | 37.88 KB | Posted: 6/7/05
How much room you have available to move your axle forward without moving the bracket vertically up ...

DSCN2226.jpg
712 hits | 34.22 KB | Posted: 6/7/05
Bracket tacked in place, comparison to stock holes

DSCN2227.jpg
871 hits | 42.97 KB | Posted: 6/7/05
bottom hole is 3" back, and a smidgen lower on the frame (this is to negate the lift lost by moving ...

DSCN2228.jpg
597 hits | 49.38 KB | Posted: 6/7/05
Top hole about 2.5" from old hole, and a tad lower

DSCN2229.jpg
634 hits | 38.01 KB | Posted: 6/7/05
Bracket in relation to stock crossmember rivet, and bottom of frame

From frame to bottom of the b...

DSCN2230.jpg
716 hits | 43.59 KB | Posted: 6/7/05
can barely get a socket on there, but will be enough to tighten it down, although that could easily ...

DSCN2232.jpg
658 hits | 33.41 KB | Posted: 6/7/05
shackle angle without any weight on it

DSCN2233.jpg
593 hits | 41.66 KB | Posted: 6/7/05
axle with weight on it, moved 3" back

DSCN2234.jpg
663 hits | 24.49 KB | Posted: 6/7/05
Shackle angle with weight on it (not TOO bad, but still a lil verticle for my taste, the rear shackl...

DSCN2235.jpg
647 hits | 32.69 KB | Posted: 6/7/05
pinion angle still pretty good ;)

DSCN2236.jpg
912 hits | 43.63 KB | Posted: 6/7/05
better pinion angle shot

DSCN2237.jpg
615 hits | 25.66 KB | Posted: 6/7/05
stock axle marking (center of hub), to current marking on right (center of hub), 3"

DSCN2238.jpg
640 hits | 21.7 KB | Posted: 6/7/05
47" to the top of my fenders

DSCN2239.jpg
678 hits | 43.15 KB | Posted: 6/7/05
Tire in relation to hight of vehicle/fender cutting

with Approx. 7" of lift