IMG_0078.JPG
1125 hits | 53.17 KB | Posted: 9/12/04
The bearings on my clutch fan were on their way out in a big noisy way. Notice the bearing seal tha...

IMG_0116.JPG
1022 hits | 51.51 KB | Posted: 9/12/04
Hayden was a quality name in cooling 25 years ago when I was in British stuff, so I went for this on...

IMG_0082.JPG
921 hits | 43.7 KB | Posted: 9/12/04
Remove the bolts holding it onto the pulley carefully as you CAN get away without removing the Sagin...

IMG_0084.JPG
912 hits | 65.06 KB | Posted: 9/12/04
Lever off the fan assembly as a unit and be careful not to let it fall and damage the radiator.

IMG_0091.JPG
789 hits | 57.55 KB | Posted: 9/12/04
Stop at this point and verify you havve the correct fan clutch. Here the new one is on top of the ol...

IMG_0101.JPG
674 hits | 56.56 KB | Posted: 9/12/04
Good time to straighten any oof the blades that are bent.

IMG_0110.JPG
788 hits | 50.38 KB | Posted: 9/12/04
Difficult to get a good angle for the camera to pick up how toasted these bearings really were.

IMG_0095.JPG
778 hits | 46.14 KB | Posted: 9/12/04
Remove the bolts holding the fan to the clutch and re-install them, and the fan, onto the new clutch...

IMG_0106.JPG
732 hits | 32.07 KB | Posted: 9/12/04
This bushing is meant to take up the space so the fan clutch can be used on more applications.

IMG_0108.JPG
731 hits | 60.58 KB | Posted: 9/12/04
I found it much easier to put the bushing onto the water pump shaft first

IMG_0110.JPG
712 hits | 50.38 KB | Posted: 9/12/04
Now gently push the unit on making sure the bolts line up so you can stitch them to draw it on the l...

IMG_0112.JPG
700 hits | 51.08 KB | Posted: 9/12/04
Once she's torqued on, you're good to go. Didn't even disturb the PS belt or pulley !

IMG_0100.JPG
729 hits | 46.92 KB | Posted: 9/12/04
Difficult getting the camera in close enough to show hoe toasted the bearings really are. I should ...