A-pillar drilled.JPG 1417 hits | 28.97 KB | Posted: 3/1/06 Holes were drilled for the gauges' wiring.
Spotlight connector.JPG 1577 hits | 50.91 KB | Posted: 3/1/06 The P71 spotlight connector and wiring in the a-pillar.
Wiring on Dash.JPG 1472 hits | 54.1 KB | Posted: 3/1/06 The wiring that will be snaked through the side of the dash. Note the coathanger coming up through t...
Wireloom Dash.JPG 1415 hits | 33.58 KB | Posted: 3/1/06 All wiring was run through this wireloom for a cleaner install and to keep the wiring together.
Tach wire through firewall.JPG 2223 hits | 33.25 KB | Posted: 3/1/06 The green wire is the tach wire, running through a grommet into the firewall.
It's blurry but you...
Tach wire engine bay.JPG 2024 hits | 35.23 KB | Posted: 3/1/06 The tach wire coming through the grommet into the engine bay.
Holes for tach adapter.JPG 2076 hits | 51.43 KB | Posted: 3/1/06 The holes drilled for the tach adapter. The pick used to pierce the grommet can be seen on the fuseb...
Power diode spliced.JPG 5187 hits | 64.83 KB | Posted: 3/1/06 The R/LG wire was cut can connected to the tach adapter. I accidentally spliced into the wrong R/LG ...
Wiring up.JPG 1990 hits | 62.43 KB | Posted: 3/1/06 I used wiring looms and electrical tape to clean up the wiring install and to give a factory appeara...
Tach adapter installation complete.JPG 1902 hits | 56.33 KB | Posted: 3/3/06 Complete. The adapter blends in well with the engine bay and the wire looms and electrical tape conc...
A-pillar tape.JPG 1840 hits | 26.07 KB | Posted: 3/3/06 I attempted to use double-sided moulding tape to install the pod to the A-pillar. However, this did ...
Mounted.JPG 2452 hits | 56.31 KB | Posted: 3/3/06 The pod and pillar mounted, awaiting the gauges.
A-pillar gauges
